Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
I reached out to Lippert and your 346005 control module was replaced with the Replacement Control Module for Lippert Ground Control 3.0 Leveling System #LC85ED. To use this control module they said you must have the Control Panel #LC421484…
view full answer...The Replacement Control Module for Lippert Ground Control 3.0 Leveling System #LC85ED is part of the Ground Control system that does have a wireless remote compatible with it like the part #LC358601. It is not a BlueTooth connection though.
view full answer...There sure is! If you use the provided links, you can see both the owner's manual which shows how to use the system as well as the installation instructions. I'll also link to a video showing a typical installation, which you might…
view full answer...The rear leveling sensor 232201 for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 4-Point Set #LC358590 on your 2016 Sanibel 5th Wheel is located towards the rear of the trailer, a bit behind the rear…
view full answer...We have heard of this issue before on the Lippert Ground Control systems #LC358590. Here is the recommended procedure for clearing the error code: Extend all jacks at least 6 inches. Then press and hold the RETRACT button until the jacks begin…
view full answer...The Air Lift compressor part #AL25804 that you referenced is capable of a max air pressure of 160 psi so it would easily fill your air bags to 60 psi.
view full answer...No, the hall effect motor does not have to be greased, but per the service manual if the jacks are down for an extended period, it is recommended to spray the exposed leveling jack tubes with lubricant every 3 months for protection. If you live in…
view full answer...Do you get any error code on the controller for the Lippert Ground Control 3.0 #LC675817? Usually that helps to troubleshoot and the manual gives an exact solution for each error code. You might also try resetting the Zero Point Calibration to see…
view full answer...Yes, the Replacement Right Rear Leg #LC344792 is the correct unit to replace the rear passenger side jack on your Lippert Ground Control 3.0 System. I reached out to my contact at Lippert and he said there aren't any specific torque specs…
view full answer...Based on the model numbers you provided, it appears that you currently have the Lippert 3.0 Electric Leveling System installed on your trailer. For a replacement motor, you will just need the Lippert Replacement Motor #LC343758. This will serve as an…
view full answer...I have a solution for you but you will need to supply your own pipe to get your desired 33-1/4 inch size. The Universal cam-door lock with 1 inch keeper #383200 will allow you to create a bar lock assembly of 33-1/4 inches. With this item you supply…
view full answer...I was able to find the service manual for the Lippert Ground Control 3.0 #LC358590 and found in that where Lippert recommends if the jacks are down for extended periods, it is recommended to spray exposed leveling jack tubes with lubricant every 3…
view full answer...Related Searches
Filter Your Search
Contact and Help