Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
To tighten the spindle nut on the end of your spindle, go ahead and put your Hub Assembly, like part #8-288-3UC1, on your spindle. Tighten it down to about hand tight and then back it off about 1/4 of a turn. Backing it off helps to keep everything…
view full answer...Unlike costlier brands of trailer jack the entry-level Pro Series line is not supported with the same repair/replacement parts availability as with the upper tier sister brands like Bulldog and Fulton. The few parts we have available to us are…
view full answer...We don't carry Dexter leaf springs, but we do offer the 4,500, 26 inch long center eye to center eye equivalent as part #e27SR.
view full answer...The Dexter 8-133 axle according to my contact at Dexter is an old motorhome axle they no longer make. Their tech said the motorhome axles like what you have are designed for one time use so there are not compatible parts made for even replacement…
view full answer...You will need to get the other bearing number from inside your current hubs before we can pick you out replacement hubs. Most likely the outer bearing you pulled is a LM67048 and the inner you have is a 25580 which would mean that the #8-201-5UC3…
view full answer...The K-Source Snap & Zap Custom Towing Mirrors #KS80930 I feel are the best mirrors extensions for your 2024 GMC Sierra 1500. These have all the cut outs for turn signals, puddle lights and cameras you may have on your mirrors. The snap on design…
view full answer...I went out to the warehouse and pulled a Recessed Trailer D-Ring Tie Down with Backing Plate and Hardware, #RR5K. The ring has an inner diameter of 1-1/4 inches and an outer diameter of 2.108 inches. The ring is approximately 0.427 inches thick. The…
view full answer...Depends on the condition of the wood but the backing plate of the Brophy D-Ring Tie Down Anchor w Backing Plate #RR5K that you referenced is designed to distribute the weight so that it does not easily rip through the wood. I attached a picture of…
view full answer...Yes, we do have towing mirrors for a 2022 Chevrolet Silverado. I recommend the K-Source Snap & Zap Custom Towing Mirrors - Snap On - Driver and Passenger Side item #KS80930. I personally drive a Silverado and I think some of the towing mirrors…
view full answer...Thank you for the kind words, the K-Source Snap & Zap Custom Towing Mirrors #KS80930 are confirmed to fit all models of the 2021 GMC Sierra 1500, that would include the Denali. The mirrors have a cut out in the bottom that fit around the…
view full answer...90-120 ft lbs of torque is probably about right for your 15 inch trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher. You'll need to know the diameter of the…
view full answer...The 3-1/4 inch diameter hole to install the part #RR5K is the correct dimension to use. We actually even had a customer come back and say they did it with a 3 inch hole saw. I attached a link to the install video you mentioned as well.
view full answer...Filter Your Search
Contact and Help