Result: winch stand

The TruRyde Spindle #TRU94FR and our Trailer Idler Hub Assembly #AKIHUB-545-2-2K are not compatible, but you could use the TruRyde EZ Lube Spindle #TRU44FR instead as it has the correct spindle measurements. For a hub that will work with the TruRyde…

Yes, the Dexter Single Axle Heavy Duty Suspension Kit part #K71-403-00 will work on tandem axle trailer you'll just need to purchase multiple kits. This is a standard kit that will work great for most trailers but if you're looking for an…

I attached a picture that we recieved from a customer that shows the CE Smith winch mount #CE31013G installed and in use on a trailer for you to check out.

Hey Roland, thanks for reaching out! Overslung axles are a special order situation and we unfortunately only have standard axles here at etrailer. With that being said, you can order a standard axle that meets your specs and then use the Dexter…

Hey Beth, welcome back. Yes, you can usually move both the spare tire mount and the kickstand forward on a Malone LowBed as long as there is room. Those components are clamped to the tongue, so physically sliding them closer to the coupler is doable,…

Based on your seal dimension being 1.5 inch and your bearing dimension of 1.06 inch on your spindle the correct bearing kit you need is the part #BK1-150.

Based on the pictures you attached and the outer bearing measurement you provided, it appears that you have 1-1/16 inch spindle like the BTR EZ Lube Spindle #TRU44FR. This particular spindle is designed for 2,000 pound axles and will use the same…

Since the Malone Microsport trailer part #MPG460G has a tongue width of 2 inches you could use the tower kit part #CE31013G which is 30 inches tall as this is designed to fit 2 inch channels. Then you could use a winch like the Buyers Products part…

Hello Dennis, thanks for reaching out. I do have a solution for adding a hand winch to your Yakima EasyRider trailer. The best way to do this is with the CE Smith Winch Stand #CE31013G. This bolts to the 2" tongue and gives you a mounting…

The easiest way to determine what size and if you have a straight spindle is to remove one of the hubs. You will then be able to either find the numbers on the bearings to verify the correct replacement or measure the spindle diameters with a Digital…

The Malone EcoLight Sport Trailers like item #MAL43FR have 8" tires with a 5 on 4-1/2 lug pattern. The Kenda 205/65-10 Bias Trailer Tire with 10" Galvanized Wheel item #AM3H490 would work as a replacement but you will most likely have to…

The Dexter Single Axle Heavy Duty Suspension Kit #K71-403-00 uses the Shackle Bolt #007-126-01. The 9/16" portion of this bolt is 2-1/4" long.