Search: trailer couplers   >   Accessories and Parts   >   !Redarc  x   >   10000 lbs  x   >  

There is no specific torque rating for the castle nut that holds your hub in place. We recommend tightening the castle nut down until it stops, and then backing it off to the next notch wheel the tang washer will fit into the castle nut. Over…

First, make sure that you have the correct size Bearing Buddy. It should be slightly larger than the hub bore though it is difficult to tell just by looking. If you can tell me the outer bearing number I can determine which is the correct model.…

Because the Retrax PRO MX Tonneau Cover #RT80467 for the 2019 Chevy Silverado 2500 covers the bed rails, you would not be able to use a ladder rack like the Thule TracRac #TH27000XT since that rack requires the use of the bed rails. The only tonneau…

Unlike passenger car tires that have a certain range the tire needs to be inflated to, trailer tires should always be kept inflated to the maximum air pressure listed on the sidewall of the tire. We offer the Kenda Karrier 145/80-12 (aka 145/R12) in…

The nut on the spindle should be tightened until snug, with no side-to-side play in the hub and then backed off slightly, about maybe a 1/8 of a turn. If the spindle uses a castle nut and cotter pin or tang nut, tighten the nut finger tight until it…

Since one end of a slipper spring is suspended instead of bolted to a hanger or shackle strap the Dexter Trailer Springs Over-Under Conversion Kit part #K71-385-00 and other likes them are considered unsafe for slipper springs. The only other option…

Yes, I do have the exact dimensions you need of the Demco Channel Tongue Trailer Coupler part #DM15945. I have attached these for you below.

The Dexter 8-283 is an obsolete 2800lb 10 x 1-1/2 inch hub that used a LM67048 inner and a L44649 outer bearing. Unfortunately, we don't have any hubs that would be compatible with the spindles on your axle. Your best bet at this point would be…

The outer thread diameter of the #K71-859-00 that you referenced is 3-3/4 inches so this would work for you based on what you mentioned.

The 168255TC oil seal is designed for use on for oil bath hubs, but they can be used on grease hubs. They basically just provide a better seal to hold oil in; they will still work for grease. The springs on your oil seals are required to function…

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…

I do have an option for you but I cannot give you exact bearing numbers for your trailer unless provided with spindle measurements or the trailer's VIN (if the manufacturer is still in business). I can however tell you that the two most common…