Recommended Tire Chains for a 2023 Rivian RS1 275/50 R22
Hello, I’m looking for low profile 16mm or smaller snow chains/cables for my 2023 Rivian RS1 275/50 R22. Would these work? Thanks! | Hey Julie, thanks for the information and the picture! I checked with Rivian and we've only got one set of tire...
Where Do You Measure From On The Trailers Coupler to Install The Pole-Tongue Adapter # EQ95-01-5950?
For the tongue pole adaptor, you mention in the video that it need to be install between 27 to 32 inches from the reveiver in the tongue. Do we mesure from the tip of the receiver or the middle, because if I mesure from the tip of the receiver...
Replacement Motor for Lippert Kwikee 32 Series Steps on 1997 Winnebago
what is the step gear and motor replacement for a 1997 Winnebago adventurer 32 | Although I managed to find an online owner's manual for your 1997 Winnebago Adventurer, it did not specify the specific steps that you have. The Winnebago manual...
Would Thule Hullavator Work With Rivian R1S OEM Roof Rack?
Im trying to install the Thule Hullavator on a Rivian R1S. I already have the Rivian Cargo Crossbars so Id prefer to use these if possible. The Hullavator requires the crossbars to overhang and the Rivian Crossbars dont. Is there a way to stackinch...
How to Tell if Power Mountain Tallboy Off-Road Bottle Jack Will Work with a 2023 Rivian R1S
what jack can you recommend for changing tires on my Rivian R1S 2023 and Intech Sol Dusk Rover off road package travel trailer? Will the Tallboy pm34fr work with a Rivian puck? | Hey Darin, thanks for reaching out! The Power Mountain Tallboy...
Will etrailer Spare Carrier # e98ZR Work with Rivian R1S 20
Does this fit a rivian r1s 20 inch all terrain tire? 275 / 65 / R20 | Hey John, yes the etrailer spare tire mount part # e98ZR that you referenced will work with the wheel and tire Rivian R1S 20 inch all terrain tire that you referenced. |
Tow Bar for 1981 Volkswagen Rabbit Pickup
What tow bar will hook up to a Volkswagen rabbit truck bumper, I need one that is 31 inches | Hi Andrew; are you saying you need the arms to be 31" apart? The Curt Adjustable Tow Bar # C19745 you were looking at has an adjustable arm width from...
Leaf Spring Recommendation for a Trailer to Stiffen Up Suspension that has 3,500 lb Axles
I have a boat trailer with a single 3500 LBS axle. It has the factory 3 leaf springs. With the boat on the trailer, the trailer seems to nearly bottom out on some highways. The load in the boat should not be considered overloaded. Would going...
Replacement Jack For 2001 Stratos Bass Boat Trailer
I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...
Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?
Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...
Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer
My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...
Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...
What is the Battery Life for Hopkins Wireless Magnetic Tow Lights
What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...
4 Pole Trailer Connector on a 2004 Chevy Venture
I installed a hitch and reese wiring kit on my 04 Chevy Venture. The wiring instructions are not great. Not much help in the steps to removing the interior trim, and mine has rear air which is not mentioned in the instructions. What do I do...
Can Second Axle be Added to Enclosed Snowmobile Trailer
I have an 8x12 hybrid enclosed snowmobile trailer with a single 3500lb idler axle. I’d like to add a second axle forward of the one it comes with. Can I safely add another axle? How do I determine the optimal placement? Will a second axle...
Location of Factory Connection Point for Trailer Wiring Harness on a 2003 Chevy Venture
Trying to install your c55355 for 2003 Chevrolet Venture Van. I cant find the trailer wiring harness plug. Ive looked at the cable bundle behind the panel and simply cant find the plug. I note that you have a video for 2002 and 2004 but not...
How to Identify Replacement Bearings, Races and Seals for Harbor Freight Trailer 92174
Recommendation for a Harbor Freight Trailer 92174 replacement bearings/seal? | The best way to determine the replacement bearing, race and seal parts needed for a trailer is to pull one of the hubs and remove them so their part numbers can be...
Wire Gauge and Circuit Breaker Needed to Wire 12 Volt Accessory Circuit to Trailer Connector
Ive not read the details in the wiring of the black 10 gauge wire that goes to the rv 12 volt battery. Ive read about using 10 gauge wiring and that it should be fused but how muchamps, and what kindslow.fast or reset. Im towing a 2000lb popup...
Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible
have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...
Where is the Trailer Wiring Connection Location on a 2000 Chevy Venture
I have torn the inside of drivers side trim completely out of my van to find where the plugin is suppose to be.The only thing I can find that even looks like it might work is at the tail light itself.Will you please help me? | On a 2000 Chevy...
Setting Up a 2004 Chevrolet Venture to Tow a 2,500 Pound Camper with Trailer Brakes
I would like to pull an ultra light 16 Camper with this van. I need a class III hitch, but do I need air bags installed? The camper weighs about 2,500 lbs. dry and we plan on pulling it about 500 miles both ways on Michigan roads. We also...
Availability of High Capacity Trailer Hitch that Will fit 34 inch Frame Measured From Outsides
I have a 1098 Renegade toterhome and stacker trailer. I am looking for the highest rated 30-40 thousand lb rating. I have talked to forklift but the person that I talked to was not very knowledgeable. Do you stock a hitch that would fit this...
Aero Bar Rhino Rack Roof Rack that Fits 2009 Volkswagen Rabbit 5 Door Hatch
Hello, I am looking at RR56RR for my 2009 Volkswagen Rabbit 3 door. Your site says it will fit but when I use the part number RV0230B into rhino racks site it states its only for the 5 door car. Which is correct? I really want these for my...
Troubleshooting Turn and Brake Lights not Working with Running Lights on, 2009 Volkswagen Rabbit
I have the same problem than the VW GTI guy. After I have wired the kit according to the 2-wire method into my 2009 Rabbit, turn and stop light are working as long as the running light is not on. I have tried also the different 3-wire methods...
Filter Your Search
Contact and Help