bing tracking image

Rabbit  x   >   R1S  x   >   RVR  x   >   CX-9  x   >  

Result:

U-Bolt Dimension of Replacement U-Bolt Assembly Y27CR

What is the center to center dimension of the legs on the U-Bolt? | The U-bolt of the Replacement U-Bolt Assembly # Y27CR is 4.5 inches from each leg on center. |

What is Required to Use Curt Echo Trailer Brake Controller

Does this wireless brake controller need a brake signal other than what would come from a 4 way line that is part of my factory wiring on my 2012 Mazda CX-9? I have converted the factory 4 to a 7 way connector but wanted to see if that wiring...

Trailer Hitch Recommendation for 2016 Mazda CX-9 with SwingDaddy Bike Rack

Weve got a hitch bike rack, the Yakima SwingDaddy. And we have just got a 2016 Mazda CX-9. I was going to get the Draw Tite 2inch trailer hitch. But when looking at the photos of it installed, realized that it may sit too far back beneath...

Recommended Tire Chains for a 2023 Rivian RS1 275/50 R22

Hello, I’m looking for low profile 16mm or smaller snow chains/cables for my 2023 Rivian RS1 275/50 R22. Would these work? Thanks! | Hey Julie, thanks for the information and the picture! I checked with Rivian and we've only got one set of tire...

Which Class 3 Trailer Hitch To get For A 2023 Mazda CX-9 Carbon Edition?

Good afternoon I’m looking for a tow hitch for my car, it’s a 2023 Mazda CX9 carbon edition, I’m looking for 2inch hitch class III I see that You have couple options available can You tell me which is best and diffrences between them? | Hi Dominik! We...

Recommended Hitch for 2023 Mazda CX-9 With Step Thru E-Bikes With Fenders

What 2- bike racks would you recommend for step thru ebike w fenders? 56lbs. Must tilt to allow hatch access and fold vertically when not in use. I have a 2023 mazda cx9 w 2 hitch. Thanks in advance! | Hey Jim! For your setup I recommend...

Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter

Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...

Would Thule Hullavator Work With Rivian R1S OEM Roof Rack?

Im trying to install the Thule Hullavator on a Rivian R1S. I already have the Rivian Cargo Crossbars so Id prefer to use these if possible. The Hullavator requires the crossbars to overhang and the Rivian Crossbars dont. Is there a way to stackinch...

Availability of Replacement Hardware for Curt Hitch # C13284

I just bought a trailer hitch Curt 13284 and it is missing some bolts. Do you sell the replacement hardware kit for this ? | Hey Jose, we sell replacement hardware for all of the hitches we carry with the part number # RHK including the Curt...

Option For Felt Saddle-Style Kayak Carrier For Roof Rack

I have some 10 years? kayak Thule Mounts - the front set are regular cradle style, the back ones are a flat felt paddle style. I could send photos with a detailed view of it I cant seem to find the same 2 felt flat paddle style paddles and...

Where Do You Measure From On The Trailers Coupler to Install The Pole-Tongue Adapter # EQ95-01-5950?

For the tongue pole adaptor, you mention in the video that it need to be install between 27 to 32 inches from the reveiver in the tongue. Do we mesure from the tip of the receiver or the middle, because if I mesure from the tip of the receiver...

Rhino-Rack Fishing Rod Carrier Vs Yakima Reel Deal

Waffling between the RR 574 and Yakima RD roof racks for my 2010 Mazda CX9 with factory roof rails and factory crossbars. Would use these for fishing rods, including 10 foot surf spinning rods and one piece rods up to 7 feet, as well as other...

Why Choose a Powered Taillight Converter Over a Non-Powered Model

What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...

Is There a U-Bolt Kit for the Yakima SkyBox 18 Rooftop Cargo Box

Can you recommend a U-bolt set up that has the width and depth clearance to accommodate Thule WingEdge crossbars? We own an older Mazda CX9 2013 with fixed points 42inch apart. We installed these crossbars and recently purchased from eTrailer...

Charging Dual Battery System on Trailer with Single Charger and Solar Option

I am wiring up 2 12 volt batteries for a 12 volt system on my small hard side camper. I plan on setting up a buss bar to allow me to wire up the charger as well as a solar system then feed to a disconnect to cut off the rest of the trailer...

Which Thule Cargo Boxes Will Fit a 2017 Mazda CX-9

I would like to know what would be the maximum size Thule roof top carrier will fit a 2017 Mazda CX9 signature variant. I saw the Thule 6297 - Motion XT - 16 Cubic Foot Cargo Box - Titan to fit this car. But is there a bigger version than this...

Do I Need to Add Washers to the U-Bolt Kit for Mounting 5,200-lb to 7,000-lb, Round Trailer Axles?

My leaf springs are under my axle, so the bracket is underneath, and the nuts are on the bottom. Do I need to use a lock washer, or will the provided nuts hold up to vibration? | Hello Tobey, The U-Bolt Kit for Mounting 5,200-lb to 7,000-lb,...

Yakima RidgeLine Fit Kit For 2022 Mazda CX9 With Factory Flush Side Rails

I have a set of Yakima Ridgeline towers a crossbar, but I need the correct clips to mount to a 2022 Mazda CX9 with factory flush side rails. Can you tell me which clips I need? | Hello Steven, thanks for getting in touch. The SightClip Fit...

Replacement Light for a Thule Transporter Cargo Carrier

Looking for replacement tail lights for Thule hitch mounted cargo carrier | Hey Eric. The Miro-Flex LED Tailer Light w/ Reflector item # STL35RB has been used for years to replace/upgrade the lights that came with the Thule Transporter cargo...

Draw-Tite Hitch 76020 Bolt Size

What size bolt is used in the 76020F hardware kit? | Hi Joseph; are you referring to the hardware for the # 76020 hitch that fits your 2021 Mazda CX-9? Outside of that I don't know what the 76020F hardware kit would be. If that is correct, this...

Which Yakima Flush Bar Roof Rack Fits 2022 Mazda CX-9

I have a 2022 Mazda CX-9 with mounting rails that are flush with the top of the car, so theres nothing to clamp onto at the bottom of the rail. The listing says Raised, Factory Side Rails, so would that only be for rails that are raised off...

Why Does Power Wire of Trailer Wiring for 2011 Mazda CX-9 Have to Run to Battery Directly

Considering one of your wiring harness for my 2011 CX-9 Mazda Found the review below and had a question. Snaps in. Well built. I tapped into the 12v power from the rear accessory outlet. I found that this is live all the time and has its...

What is the Thread Pitch of the Replacement Carriage Bolt - M6 x 75mm TH915-0675-11?

What is the thread pitch? | Hey Glen. The Replacement Carriage Bolt - M6 x 75mm item # TH915-0675-11 has a 1mm thread pitch. What are you needing a replacement bolt for? |

Shipping Measurements of Curt Trailer Hitch Receiver # 13575

I need to buy a piece to hitch receiver for my Mazda cx9 2015 I will be in Las Vegas next week. Do you think I can receive it there.. Could you give me size of the box ? | I went down to our warehouse at etrailer.com to take the measurements...

Filter Your Search