bing tracking image

RVR  x   >   Rabbit  x   >   RST  x   >   RX 400h  x   >  

Why Choose a Powered Taillight Converter Over a Non-Powered Model

What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...

Looking for Hitch Solution for 2004 Monaco Dynasty Coach

Morning Have a customer looking for a trailer hitch assembly for their 2004 Monaco Dynasty coach Diesel pusher The original hitch appears to have been cut off with a torch Any help on this would be greatly appreciated | Hey Bill, I wish...

Recommended 4-Pole Trailer Wiring Harness for 2006 Lexus RX 400h

I dont find a plug and play tow vehicle harness for a 2006 Lexus RX400H Would a 2006 Highlander harness be used on the Lexus, thought they may be close to similar. thanks. | The reason there are no plug-and-play trailer wiring harnesses for...

Replacement Jack For 2001 Stratos Bass Boat Trailer

I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...

Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer

My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...

Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load

What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...

How High Will CE Smith 13 Inch Bolster Bracket Sit Above 3 Inch Crossmember

I am going to be replacing rollers with bunks on my ez loader trailer. The boat will need to sit rather high due to the width as the boat will need to be above the wheel fenders. For the two inside bunks, the boat will need to be at least...

What is the Battery Life for Hopkins Wireless Magnetic Tow Lights

What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...

Can The Spare Tire Still Be Accessed After Installing The Etrailer Hitch On A 2007 Lexus RX 400H

For a 2007 Lexus RX 400h. Is the hitch built so the spare tire will come down as it should if needed? | The etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2" Item # e98857 on your 2007 Lexus RX 400h does still...

Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?

Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...

Towing Capacity and Parts Needed for 2006 Lexus RX 400h

I know nothing about cars. Can you explain it to me like a toddler....in not kidding. Ive been googling for hours and half of my googling is just for mechanical terms. I have the Lexus rx400 2006 model. Im planning to tow a 2000lb trailer, will...

Trailer Hitch and 4-Way Wiring Recommendation for 2018 Mitsubishi Eclipse Cross

I need a hitch and 4 wire harness for a 2018 mitsubishi eclipse cross | For your 2018 Mitsubishi Eclipse Cross we have the Curt hitch # C13273 which is a confirmed fit and then for 4-way wiring you'd want the part # C56296 and you'd be set. |

How to Reattach Spare Tire on a 2006 Lexus RX 400h After Hitch Install

How do you get the full size spare tire back in place without removing the hitch. The tire hits on the front cross member suspension and hitch. There is no clearance for it to pull up into place. | The Curt Trailer Hitch Receiver part # 13530...

Convert a 4-way to a 7-way on a 2006 Lexus RX400 H

Hi, My 2006 Lexus RX400 H already has a 4 pin wiring harness hooked up and working. How do I transform this setup into a 7 Pin setup so I can tow a small trailer? Lance Trailer 1575 Thank you, | If the trailer doesn't have brakes all you...

Troubleshooting Rhino-Rack Roof Rack Installation on 2018 Mitsubishi RVR Flush Rails

Ive tried to install the kit of the SX031 legs on my 2018 RVR, but if you look at the pics those legs are not straight on the flush rails so when I have the bars on them then they dont fit anymore... Am I doing something wrong or I got the wrong...

Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible

have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...

How to Torque the Curt Class III Trailer Hitch # 13530 on a 2006 Lexus RX400h

When installing part number 13530 can I just manually torque it, or do I need an electric torque to get to the 36lb-ft req from the installation instructions? | When installing the Curt Class III 2 Inch Hitch, part # 13530, on your 2006 Lexus...

Trailer Hitch and Wiring for a 2008 Lexus RX 400h

Will this hitch fit a 2008 Lexus RX400H? | Yes, Curt trailer hitch # 13530 fits your 2008 Lexus RX 400h. I have linked a video showing an example installation for you. If you plan on doing some towing I recommend etrailer ball mount kit # 989900....

Aero Bar Rhino Rack Roof Rack that Fits 2009 Volkswagen Rabbit 5 Door Hatch

Hello, I am looking at RR56RR for my 2009 Volkswagen Rabbit 3 door. Your site says it will fit but when I use the part number RV0230B into rhino racks site it states its only for the 5 door car. Which is correct? I really want these for my...

Trailer Wiring Harness Availability for a 2008 Lexus RX400h

I have a 2008 Lexus RX400H with the factory trailer tow package. Apparently there is a wiring harness at the back of the vehicle where I can hook up another harness that will work for a trailer. It is supposedly a plug that plugs into the factory...

Will the Thule OutWay 2 Bike Trunk Mount Bike rack Fit a 2008 Lexus RX 400h

Will TH45JV fit a 2008 Lexus Rx 400 H? If not, what would you recommend? Thanks | Thule does list the OutWay, # TH45JV, as a fit for your 2008 Lexus 400h. I have included a link to a video review of the Raceway series of bikes. The video features...

Troubleshooting Turn and Brake Lights not Working with Running Lights on, 2009 Volkswagen Rabbit

I have the same problem than the VW GTI guy. After I have wired the kit according to the 2-wire method into my 2009 Rabbit, turn and stop light are working as long as the running light is not on. I have tried also the different 3-wire methods...

How to Prevent Exhaust Components from Contacting the Trailer Hitch

I purchased the replacement CURT trailer hitch hardware from eTrailer for this hitch and installed the 11074 on my 2009 4DR Rabbit. However - after install, I now experience a lot more noise at low RPMs. Theres vibration being transmitted back...

How Does the Curt Hitch # 13530 Affect Lowering the Spare Tire on a 2006 Lexus RX 400h

Re: 2006 Lexus 400h trailer hitch 13530 from Curt. I wonder how this hitch affects the lowering of the spare tire. It would appear to be a very tight fit, but perhaps all it takes is a push forward on the tire as it is lowered? The OEM part...

Filter Your Search