Result:

I recently purchased the Curt Trutrac WD C17501 for my 2004 Ford Excursion towing a 39ft travel trailer. The tongue weight loaded is around 1100 lb. The RV dealership installed the weight distribution on my trailer and set it up but after driving...

Good evening, I am inquiring if there is a 3 prong 3 wire plug for this brake light STL29RB that I could solder and then plug into a existing wire harness for a trailer. Thanks. | Yes, there is Jeff. We actually have three different 3 prong...

What roof rack would you suggest? I saw the response regarding the 2002 and wondered if it would be the same as a 2004. | We carry roof racks for your 2004 Ford Excursion as long as you have the factory tracks that run front to back on the...

This part DOM63FR says that it fits a Dometic 310 toilet, but my specific Dometic 310 product 9108552772 is not listed among the compatiable products in the item description. Will this Replacement Flush Ball Seal fit my model? | Hey Steve!...

Will this hitch mount fit the Superwinch SX12SR so long as the load does not exceed the 9000Lb capacity of the winch hitch mount? Thank you | Yes, the winch hitch mount part # SW2050 that you referenced would work with the Superwinch SX12SR...

The two plug brake control adapter I ordered 2004 F250 SD Tekonsha P-3 does not seem to be the correct one. I have a flat 4pin inline connector mounted just under the dash just forward of the accelerator pedal not behind fuse panel cover that...

I have 2004 Ford Excursion. I am in search of a “reliable” and “functional “ back up camera. The function I want it to perform is aligning my trailer ball to the trailer hitch. Can you please make some suggestions on the camera to buy. Thank...

Can you back up with this WD system? | With weight distribution systems like the Curt part # C17422 you can backup as long as you mainly are going straight back. If you find yourself in any jackknife situations you would need to disconnect the...

my is 2004 rodeo 3.5 liters wish i will use | The only trailer hitch that will fit the 2004 Isuzu Rodeo with 3.5 liter motor is Curt hitch # C13235. But in order for this hitch to fit your Rodeo must have the rear door mounted spare tire. It...

Have an 04 Base Model 5.4 V*8 Excursion 4 Wheel drive. Can i tow it flat? If so, your best value base plate and 7k lb tow bar system including wiring on Excursion? No Brake components needed. Already have Roadmaster Falcon system mounted...

My excursion has f350 leafs on it which gave me 2.75inch of lift. Will the excursion kit still work or will the bushings be too short still causing it to sag before they make contact. | Because the stock ride height has changed, the # TFREXC4...

Want to build heaviest tandem possible w/surge and axle-less susp. complete parts list would be most helpful. | The highest capacity Timbren Axle Less system is the 7k part # TASR7KS01 which can be used on a tandem axle trailer. For brake...

Can I install a trailer hitch with the spare tire mounted underneath on this model. It is a 2 wheel drive. | Yes, there are trailer hitches available for the 2004 Isuzu Rodeo that have the spare tire mounted underneath the vehicle. I have included...

Hi, I am looking for some way of transporting 3 kayaks on our 2004 Ford Excursion. It has the factory roof rack already but Im not sure if there is some J brackets that would fit the factory racks or Id replace the rack. Could you see if there...

Received my new shank for my 2004 Ford Excursion with a 2” receiver. It seems to fit looser then the one I had. Is there a shim or to snug this baby up? Thank you | Hey Stephen, what you'd want is an anti-rattle device like the Curt part #...

I am not a mechanic and i have not installed this system. It worked fine for sometime. Its a Firestone dual air leveling kit for a 2WD ford excursion, with Analogue gauge. When buttons are pushed up, usually the compressor engages and the inflation...

this hitch claims a significantly higher weight rating than the stock hitch on my 2004 ford excursion 4x4, but looks to be virtually identical. what can you tell me about the size and thickness of the tubing and mounting plates? | The main...

What is the correct model to use for my Harley road king? Is it the 2301, 2302 or 2303? | The correct B and W Biker Bar for the Harley Road King is the Touring model part # BWMC2301 that you referenced. |

I bought the P3 with the adapter cable for a tow pkg 2004 ford excursion. The controller has not seen any trailer that i have connected to the factory 7 way. I have changed the factory 7 way trailer connector on the excursion and there is...

Looking to purchase roof rack bars for my 2004 ford excursion. They offer them for EL model and excluding EL model. What do you mean by EL model? | EL means extended length. It doesn't affect the roof rack because the available options we have...

Im looking for a roof rack for Ford Excursion. I dont want a small width product. I want something like 79 or 80 inches. I need some roof rack feet that attach a oem Ford factory roof rack to something like a Thule Pro bar Evo cross bars....

Instructions for RP66074 | There are 2 instructions links for the Reese Strait-Line Weight Distribution system, # RP66074. I have included updated links to the instructions for you to view. One is for the weight distribution system itself....

I have two trailers I would like to mount the sway controller on. Is it possible to buy an additional mounting plate and accessories, so I dont have to buy two complete controllers? I can only tow one at a time! Thanks for the excellent customer...

Will this hitch fit on the Rodeo with 3.5 liter motor? | The Curt trailer hitch # C13235 is designed to fit 1998 to 2004 Isuzu Rodeo models with a door mounted spare tire. It does not matter which engine you have for the Rodeo. I have included...