Trailer Lights Specs:
Features:
...for application and mount with peel-and-stick adhesive backing Hardwires to any 12-volt power source with 2-Wire pigtail Available snap-on connector allows you to easily attach 2 sections of LED light...
More Information >LED Strip Lights Specs:
Features:
...outdoor locations. Surface-Mount Light Surface-mount trailer lights install using a flange or bracket with mounting holes. These lights lay flat against the trailer surface and only require a small, often...
More Information >LED Strip Lights Specs:
Features:
...replace - no brittle filaments Durable polycarbonate lens Clear lens with white LEDs Compatible with 12V DC systems Surface mounts to a flat surface with wedge base - hardware not included 2-Wire design ...
More Information >LED Strip Lights Specs:
Features:
...polycarbonate housing and lens Clear lens with white LEDs Compatible with 12V DC systems Surface mounts to a flat surface with wedge base - hardware not included 2-Wire design - includes ground wire and lead wire...
More Information >LED Strip Lights Specs:
Features:
...lumens: 550 lumens Diodes: 9 Power draw at 12V: 0.375 amps IP rating: IP67 Lifetime warranty on LEDs Surface-Mount Light Surface-mount trailer lights install using a flange or bracket with mounting holes...
More Information >LED Strip Lights Specs:
Features:
...filaments Polished chrome finish on polycarbonate housing Clear polycarbonate lens with white LEDs Sealed, waterproof construction has an IP67 rating Flat base for surface mounting 2-Wire pigtail - includes...
More Information >LED Strip Lights Specs:
Features:
...LED light strip attaches to awnings to provide sideways light Warm white light with light starkness Compatible with Thule mounting rail TH301644 Can be used both when the awning is opened...
More Information >LED Strip Lights Specs:
Features:
...Flexible LED strip provides light inside or outside your RV Warm white light with light starkness Compatible with Thule mounting rail TH306777 60-70 power LEDs per 3' Power consumption...
More Information >Trailer Lights Specs:
Features:
...replace - no brittle filaments Durable polycarbonate housing and lens Clear lens over white LEDs Surface mount - hardware not included 2-Wire design - includes lead wire for power and ground wire Specs...
More Information >LED Strip Lights Specs:
Features:
...won't have to worry about replacing bulbs that have brittle filaments. And because LEDs draw minimal power, the light won't drain your battery or overload your circuits. Surface-Mount, Bolt-On...
More Information >Videos
for RV Exterior Lights
Help Articles
for RV Exterior Lights
Expert Answers
for RV Exterior Lights
Hey Barry, so the GE Profile Propane RV Range with Glass Cover #GE24VR used to come with a glass lid but it looks like they updated it and got rid of that part.
view full answer...Hey Dick, Extra space for mounting and breathability for the unit itself is why the manufacturer lists the cutout hole needing to be 22-7/16" wide x 15-3/16" tall. That being said if your cutout hole is smaller but can still fit the #HP99ZR…
view full answer...Hey Troy, with the Dometic Penguin II with heat pump part #DMC38ZR you can use a wall thermostat with the part #DMC23ZR and the manual air box part #DMC43ZR but there isn't a remote controller option available at this time.
view full answer...Hey Rodney, it sounds like you've done your homework! That MoRryde set up you referenced is definitely going to upgrade your Dutchman's suspension and make towing it more comfortable. You'll want to take two measurements before ordering…
view full answer...The lens on the RV Oval Porch and Utility Light #RVPL7C is held to the housing with some tabs on the lens that fit slots on the housing. To remove the lens you will need something thin and flat like a knife or small screwdriver to gently pry the lens…
view full answer...Hello Richard, thanks for reaching out. You are correct the Advent AC Units like part #ACM150 are generally not going to be compatible with the Duo-Therm AC systems. Especially since your current unit is so old. Your best option will be to replace…
view full answer...Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…
view full answer...Hello Robert, thanks for reaching out. The best option for this will be to replace your rooftop AC, controller and distribution box. Do you prefer a wall thermostat, or a distribution box with manual controls on the ceiling? We have options for both,…
view full answer...I've attached the installation instructions for the Progressive Dynamics Pure Sine Wave Inverter w/ Transfer Switch - Remote - 2,000 Watts - 12V #PD64FR for you below.
view full answer...I have a solution that may work for you, but we do not currently have any 3" diameter submersible reverse lights. Have a look at the Optronics Backup Light #BU45CB which is a 4-1/4" diameter light that can be mounted to your trailer using…
view full answer...Hey Steven, so we have the Dometic Penguin Ii High Capacity 15k btu RV AC unit part #DMC33ZR which has a heat pump built into it like you are wanting. You will also need the air box part #DMC43ZR. If you were looking for something a little easier on…
view full answer...I am glad you were able to avoid a loss from your cargo trailer by using an alarm system. It sounds like you have (had) a cam style door lock like #3057-55 and #305736 on your cargo trailer's rear door. These can be locked with items such as…
view full answer...