Trailer Lights Specs:
Features:
...Amber trailer reflector Self-adhesive backing allows for easy stick-on application Made in the USA Specs: Dimensions: 4-5/16" long x 1-11/16" wide Limited lifetim...
More Information >Trailer Lights Specs:
Features:
...Red trailer reflector Self-adhesive backing allows for easy stick-on application Made in the USA Specs: Dimensions: 4-5/16" long x 1-11/16" wide Limited lifetim...
More Information >Videos
for RV Exterior Lights
Help Articles
for RV Exterior Lights
Expert Answers
for RV Exterior Lights
A 16 inch tire will not fit on a 16.5 inch wheel. You would either need to get new 16 inch wheels with the proper bolt pattern to match what the hubs require or to get your existing wheels you would need to go with 16.5 inch tires. You mentioned…
view full answer...While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our…
view full answer...For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring…
view full answer...Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center…
view full answer...The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still…
view full answer...If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…
view full answer...The first thing to do is disconnect the trailer from the Liberty. Then using a circuit tester, like part #PTW2993, test each pin of the 4-Way. Clip the alligator clip of the circuit tester to the exposed post, the ground wire. Check each pin with…
view full answer...The Bolt hitch lock part #BL7023582 that you referenced does fit your 2014 GMC Sierra 1500. I attached a chart that has all of the vehicle this works with. I also attached a link to a review video for this lock for you to check out as well.
view full answer...Yes, the Bolt Trailer Hitch Lock part #BL7023582 will work for you as it is a hitch lock designed for 2-1/2 inch hitches like what you have on your GMC 3500 truck. The usable portion of this lock is 3.55 inches. Check out the picture I attached for…
view full answer...I checked directly with BOLT for you, and they confirmed for me that your 2021 Chevy Silverado is absolutely compatible with their trailer hitch locks. Take a look at the accompanying photo, and if you have the same center cut key, the correct lock…
view full answer...On equalizer 013-105-04 in kit #K71-360-00 the eye center to eye center measurement is approximately 7-1/2 inches.
view full answer...It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…
view full answer...Filter Products (4)