2012 Aliner Classic Camper RV Exterior Lighting

I have a solution that may work for you, but we do not currently have any 3" diameter submersible reverse lights. Have a look at the Optronics Backup Light #BU45CB which is a…

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x…

Yes, it will and hello! The Triple LED Trailer Tail Light item #CE44VR is the direct replacement for the older Command 003-30. It's got the upgrade LED's…

Hi Ken; I reached out to Lippert on this and they were unable to find the specific pressure from the #LC689052 testing. It is a large company and sometimes information gets lost across it with other brands like the Flow Max. I would say the pump is…

You have a good eye as the black tubing sections are plastic for the Camco Gen-Turi RV Generator Exhaust System #CAM44461. It's just the curved pipe section that is made out of stainless steel.

The side plates of the B&W gooseneck trailer hitch #BWGNRK1313 will mount on the outside of each frame rail of your 2004 Dodge 2500 8-foot bed. See the B&W video…

Your air bag mounting location will determine compatibility with the Gooseneck trailer hitch #BWGNRK1313. The side plates of the gooseneck trailer hitch #BWGNRK1313 will mount on the outside of each frame rail. See diagram to the right and video…

I have a solution for you, but the main issue with puck style lights that mount to the surface of your RV ceiling or under cabinets, is that there aren't replacement bulbs available and they…

I didn't receive a picture which you can email to me directly if you would like. However, since you have a Dexter D60 axle you will need the Bearing Kit, 14125A/ 25580 Bearings, 10-36 Seal item #BK3-200…

There unfortunately isn't a guide that lists the parts used on your trailer so you'll need to do a bit of investigating to see what you currently have so that we…

To replace the motor on the LCI Pump 650057 we have the Replacement Motor #LC167576.

There is a tab on the top of the Porch Light part #DG52526PB that you will push down with a small slot screwdriver which will allow the cover to pull forward and give you access to the mounting screws on the base of the light.