What our customers are saying:
Very fast service. Shipped out an hour after I ordered it.Thanks!!
Robert
Westfeild, PA
Videos
for RV Camera System
Help Articles
Expert Answers
Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…
Hey James, you can go with a 4k axle leaf spring like the part #e22YR in place of what you have now while it has a slightly higher weight capacity it's not enough that it would create a harsh ride quality. This is a 26 inch long spring though so…
Hey Luke! What kind of trailer do you have? Yes, the Furrion Vision S+ Wireless RV Backup System #FR57AD will fit where the old Vision S was. They use the same mounting bracket and wiring so it should be an easy swap. The only thing that isn't…
Hey Alfredo! Great question. The Furrion Vision S+ Wireless RV Observation System #FR57AD, #FR74AD, and #FR64AD are all capable of recording. The 7" monitor has a micro-SD card slot (must be at least Class 10) and supports cards up to 128GB.…
Hey Tom! The MORryde Cushioned 5th Wheel Pin Box is an awesome system and will greatly improve your towing experience. Based on the sticker you have a Lippert 1621 pin box. Also, thank you for providing the GVWR of your 2018 Heartland Pioneer PI287…
The Furrion camera system we have is a closed system and would not be compatible with the in-dash display so you would need to purchase GM's camera system to be able to connect to your display instead of having another monitor. If you do end up…
Hello Ken, thanks for reaching out. Sadly, the Furrion Vision S camera system is being discontinued and replaced with the Vision S+. The camera for the Vision S+ is not backwards compatible with the Vision S system, so sadly if your camera is bad,…
The Voyager WiSight Wireless RV Backup Camera System #ASA37YR you were looking at is only compatible with the RV Backup Camera #ASA74YRor #WVH100 so this would need to be the camera you already have installed or you would need to replace the camera.…
Thanks for reaching out, i have a couple things for you to do. Let me explain below: *12V PWM Filter for RV Backup Camera Systems - Hardwire #VGR64VR. The newer GMC vehicles use PWM(Pulse With Modulation) in their electrical systems. The Furrion…
Thanks so much for the photo, it was super helpful, and what it shows is that your trailer has the Voyager WiSight Pre-Wire Plate. This will allow you to mount the Voyager WiSight camera system: - Voyager WiSight Wireless RV Backup Camera System…
The Voyager WiSight 2.0 you referred to, part WVSXS43 which we offer as part #ASA84YR isn't compatible with the first generation 1.0 system. The good news is that installing the new system will be pretty simple. The new camera can use the same…
I am sorry to be the bearer of bad news Gregg but your Voyager camera WVCMS130AP is part of the first gen camera system, which we no longer carry since it's been discontinued by the manufacturer. Voyager was considerate enough to make sure their…
2020 Northwood Accessories
Towing
2020 Northwood Trailer Hitch
2020 Northwood Blind Spot Detection
Performance Accessories
2020 Northwood Tire Chains
Vehicle Trim
2020 Northwood Wheel Cover
RV and Fifth Wheel
2020 Northwood RV Vents
2020 Northwood RV Mattress
2020 Northwood RV Covers
2020 Northwood RV Weight Distribution
2020 Northwood RV Hubs and Drums
2020 Northwood RV Brakes
2020 Northwood RV Roof Membrane
2020 Northwood RV Bearing
2020 Northwood Trailer Jack
2020 Northwood Spare Tire Cover
2020 Northwood RV Camera
2020 Northwood RV Doors
2020 Northwood RV Propane
2020 Northwood RV Interior Lighting
2020 Northwood RV Exterior Lighting
2020 Northwood RV Jack Pads
2020 Northwood RV Bike Racks
2020 Northwood RV Antenna and Radio
2020 Northwood RV Air Conditioner
