RV Antennas Specs:
Features:
...Jensen AM/FM antenna Rubber mast Top or side mount Overall dimensions: 2-3/4" diameter x 16-1/2" tall Cable length: 8'3" 1-Year warranty...
More Information >RV Antennas Specs:
RV Antennas Specs:
Features:
...Jensen antenna Adjustable ball base for top or side mounting Mast with spring Overall dimensions: 2-3/4" diameter x 31" tall 180" Detachable cable 8' Braided ground lead 3-Hole...
More Information >RV Antennas Specs:
Features:
...Jensen 2-piece di-pole antenna Small, flexible structure allows for easy installation in tight, hard-to-reach places In-wall installation provides clean look AM/FM 6' Long 1-Year warranty...
More Information >RV Antennas Specs:
Features:
...Jensen pull-up antenna 39" Mast 48" Cable AM/FM Top mount Collapsible - 5 section Removable rubber cap allows for rod to disappear within antenna housing Locking application - key included...
More Information >RV Antennas Specs:
Features:
...Jensen amplified antenna Mounts easily using adhesive foam strips AM/FM Long range LED power light Requires 12-volt DC Overall dimensions: 14-1/2" wide x 7/8" tall x 3/4" deep Cable...
More Information >RV Antennas Specs:
Features:
...Jensen RV antenna 90-Degree adjustable base for top or side mounting Rubber mast prevents breakage typically associated with metal mast antennas Rubber gasket provides watertight mounting 14"...
More Information >Videos
for RV Antennas
Help Articles
for RV Antennas
Expert Answers
for RV Antennas
Hey Erik, It's common for the light on your Furrion stove's knob to stay on if it senses that the oven is on. Since you're clearly not running the oven but it's still on and staying red instead of changing to blue that would indicate…
view full answer...Hey David, The LaSalle Bristol RV Roof Replacement Kit w/ XTRM Membrane #344270KIT30 does need to be installed on a clean surface per the installation instructions: - Make sure the deck is clear of all debris. NOTE: XTRM PLY membrane must be…
view full answer...The Dexstar Conventional Steel Wheel with Offset - 14" x 5-1/2" Rim - 5 on 4-1/2 - Black #AM20304 you referenced is a conventional wheel that should work with most baby moons. We have baby moons #AM90086 that I can confirm as a fit that…
view full answer...I spoke with Furrion and found that this is a known issue with the wiring on the side marker cameras #FCE48TASL. A lot of people have been installing the trigger wire in with the power wire instead of running it to the turn signal or just capping it…
view full answer...Hey Gary, yes we do have a white version of the MaxxFan Dome Roof Vent with the part #MA00-03812W. We also have it with an interior light too with part #MA00-03810W.
view full answer...The Replacement Door #AT91385 will fit your Atwood RV Water Heater #AT94022 (GC10A-4E) on your 2016 Jayco North Point 5th Wheel camper.
view full answer...Hey Steven, so I am not sure why MORryde did it this way but you can't add their lift assist setup to the versions of the StepAbove steps that didn't come with it. Only solution would be an all new step setup that has them like the part…
view full answer...That is a great question. Both of those are great weight distribution hitches. Between the two, I prefer the Reese Dual Cam II over the Strait Line. The Dual Cam uses an L-bracket to attach to the frame, instead of a chain and lift bracket.…
view full answer...Hello Jerry, We have a rack that will work for you, but the Swagman Escapee RV Bike Rack #S39SR will not work with bikes that have fenders. I attached an image to show how the bike rack clamps down on the wheel, the fender would be in the way. The…
view full answer...The globrite 122 in red or yellow/amber are 3.75 inches by 1.70 inches from what I can find online. We do not have a direct replacement, however the closest dimension we have to replace them is 3-1/2 by 1 inch. I recommend the #MC68RB and #MC68AB. If…
view full answer...Hey Ron, good to hear from you! How long are your current U-Bolts? The U-Bolt Kit #APUBR-8 could potentially work as it has 7" long U-Bolts, but it really boils down to what you currently have. For something longer we have the MORryde U-Bolt Kit…
view full answer...Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY38FR that you referenced.
view full answer...Filter Products (7)
Contact and Help
What our customers are saying:
I received this order yesterday. Thanks for the outstanding service. I appreciate it! Thanks, Alex
Alex
Blowing Rock, NC