1978 Lincoln Continental Radiator Fan

Hey Anthony, do you have a cam lock currently? Like on the outside all you see is a lock core and on inside there's a little arm that grabs the inside of the door? Or is there a cut out already? Either way you could use a slam latch like the part…

Hello Bob. We do have a good gas detector option for you, but the lp gas detector model 7719 is currently unavailable. What I recommend instead is the RV Propane Gas Detector #RS44FR. This is a pretty standard gas detector. Just keep in mind the…

Hey Mark, I found a couple articles online that said it should be possible by just making some holes bigger but I was not able to find a walk through or guide on exactly what to do. I would think a mounting plate style lock like the part #GL34FR…

Hey Timothy, I reached out to my contact at Thetford and they said you need one of the following parts: - 42067 KIT, PEDAL HIGH WHITE STYLE II - 42078 KIT PEDAL LOW WHITE STYLE II These are made to order so you'll have to get it through them…

Electric fans do improve fuel mileage and power since they allow the accessory belt drive to turn with less resistance. I did the same conversion on an older Camaro years ago and it cooled better, improved mileage, and power. You'll have to…

The Flex-A-Lite radiator fan part #FLX295 is the correct size and is a fit for your 2004 Toyota Sequoia but it is not an OEM replacement so it does not use the exact same mounting points of old fan. You will have to use the included mounting hardware…

I sent an email to Furrion to get that info from them.

The correct replacement control module for your Kwikee Series 32 Steps is the Lippert Components Kwikee Control Unit part #LC379606. The motor you'd need is the part #LC379147, and the linkage the A linkage part #LC379160. If you needed all of…

You can install a stack cooler in your vehicle. The Class ratings are there as a reference point to a hitch Class. For example if someone has a Class III hitch they can look at coolers, see a Class III and say, hey, I have a Class III hitch so this…

For your wife's 2005 Dodge Dakota, I recommend the Draw-Tite Max-Frame Trailer Hitch Receiver part #75251 which is a Class III hitch with a 2" receiver tube opening. As long as you do not have a factory trailer hitch then this option will…

The Flex-a-lite 15" Black Magic Xtreme S-blade Fan w/ Thermostat Controller - 24V - Reversible #FLX18024 is sold as a fan assembly with motor and thermostat, but does not come with any mounting hardware as the installation will vary across…

According to my Curt Representative, the Class IV #14053 or the #13053 Class III hitch is a fit for the 1990 Ford E350 Van. The Class IV hitch has a 1000 lb tongue weight 10,000 lb towing capacity. The #13053 Class III has a 500 lb tongue weight,…