Replacement Weld-On Coupler For A-Frame Trailer
Published 11/11/2014
Question:
Will this fit my A-frame trailer?
asked by: Gaary B
0
Expert Reply:
The A-Frame Coupler, part # CA5100B is a weld-on coupler that will fit a 2 inch trailer ball.
This coupler has a 5,000 lb weight capacity, and also features a 2-1/4 inch diameter hole for a jack to be mounted. I have attached a photo of this coupler with some dimensions noted you can check out. And I have attached a link to a product review video for this coupler.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
A-Frame Coupler with Black Paint Finish - 2" Ball - 5,000 lbs
- A-Frame Trailer Coupler
- Standard Coupler
- 50-Degree Frame
- Weld-On
- 5000 lbs GTW
- 2 Inch Ball Coupler
- Trigger Latch
- 2-1/4 Inch Hole
- Standard Grade
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement for Shelby 5101 Coupler
- Q&A: Recommended Soft Start for a Furrion AC Unit
- Q&A: Brake and Hub Compatibility for a 2,000-lb Trailer Axle with L44643 Bearings
- Q&A: Replacing the Drop Leg Spring Loaded Pull Pin on a Bulldog 180 Series Square Jack
- Q&A: Replacement Gear Kit Instructions and Diagram for Ram 12,000 Series
- Q&A: Looking for Replacement Breakaway Battery for Old Battery Break Way Corp 081020FHon Battery
- Q&A: Do You Have a 2-inch Square Axle Rated for At Least 3,000lbs and Has Idler Hubs?
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How Does a Trailer Hitch Coupler Work?
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)