Recommended Clearance Lights for Vintage Trailer
Updated 11/04/2014 | Published 11/03/2014
Products Featured in This Question
Question:
Hi, Im restoring a vintage trailer. I like a few of you clearence lights but they are two pronged. My trailer is set up for one wire lights. Can I convert them? Thanks
asked by: Pete
Expert Reply:
One of the prongs on the back of the clearance lights you referenced is for the ground wire which you will tap to a clean, metal surface. The other wire will be spliced into your trailer wiring.
I recommend using a plug like the Optronics Two Wire Pigtail for Sealed Trailer Clearance Lights # A46PB.
Check out the video review for this part that I have included at right.
Product Page this Question was Asked From
GloLight LED Trailer Clearance or Side Marker Light - Submersible - 6 Diodes - Round - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 2 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: Outside Diameter of 2 Inch Round Grommet
- Q&A: Are 7k Brake Assemblies Available in Left and Right Hand Side Individually
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Q&A: What Hitch will Not get in the Way of My 2025 Subaru Forester Hands Free Lift Gate?
- Q&A: Comparing O-Track Cargo Control System And L-Track System
- Article: Trailer Lighting Requirements
- Q&A: What Replacement Equalizer Do I Need for My TrailAir With Upgraded Shackle Kit?
- Q&A: Need a Replacement Axle for my Trailer
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)