Dimensions for License Plate Holder C31002 When Used in the Upright Position

Published 03/03/2010

Question:

im looking at your front receiver licence plate holder. im thinking of turning it over to have move clearence under it. how close is the 2x2 to the bottom of the holder? outside of the reciever to edge of holder?? 2-3??

asked by: david

Expert Reply:

I went to our warehouse and measured the license plate holder, and when # C31002 is used in the upright position, the top of the face plate sits 4 inches above the top of the shank. The bottom of the face plate would be 5/8 of an inch below the bottom of the shank.

The edges of the face plate are 5-1/8 inches from the sides of the shank.

expert reply by: Sarah L