Checking Lippert LC283280 Shock Fitment on a 2025 Stryker 2314 With Factory Brackets
Published 11/17/2026 >
Products Featured in This Question
Question:
I have a 2025 Stryker 2314 toy hauler, 2 Dexter 5200lb axle 3tube underslung with Dexter E-Z flex equalizer. It has factory shock mounting bracket welded to the frame and the shock bracket mounted to the springs It is 12-3/4inch face to face of the mounting brackets. Will the Lippert 283280 HD shock work with this mounting space.
asked by: Tom H
Expert Reply:
Hey Tom.
If you have existing shocks on the factory mounting brackets, I recommend taking some measurements to see if this # LC283280 will fit in its place. This shock measures 8-5/8" fully compressed and 13-1/2" fully extended. Keep in mind, these measurements are taken between the inner washers, not between the mounting bracket faces.
Lippert's mounting instructions say to measure the shock at half stroke, then add 2" for locating the upper bracket.
The 12-3/4" measurement isn't enough to guarantee this is a proper fit. However, this shocks halfway travel is roughly 11-1/16" between the inner washers, so I recommend verifying that that your existing brackets accommodate the shock and its bushings at that position.
Do you have shocks currently installed, or just the mounting brackets?
Expert Reply:
Hey Tom.
If you have existing shocks on the factory mounting brackets, I recommend taking some measurements to see if this # LC283280 will fit in its place. This shock measures 8-5/8" fully compressed and 13-1/2" fully extended. Keep in mind, these measurements are taken between the inner washers, not between the mounting bracket faces.
Lippert's mounting instructions say to measure the shock at half stroke, then add 2" for locating the upper bracket.
The 12-3/4" measurement isn't enough to guarantee this is a proper fit. However, this shocks halfway travel is roughly 11-1/16" between the inner washers, so I recommend verifying that that your existing brackets accommodate the shock and its bushings at that position.
Do you have shocks currently installed, or just the mounting brackets?
Product Page this Question was Asked From
Lippert Heavy-Duty Replacement Shock - Yellow
- Accessories and Parts
- Trailer Suspension Parts
- Shocks
- Lippert
more information >
Continue Researching
- Q&A: Measuring to Determine the Right Size Shock to Use on a Trailer
- Q&A: Replacement Shock for Dexter Axle 052-003-00
- Q&A: How to Identify Correct Replacement Electric Drum Brakes for 1987 Avion Travel Trailer
- Q&A: Recommended Replacement For A Dexter Axle 052-003-00 Trailer Shock Kit
- Q&A: Length of Shocks on Lippert Bolt-On Shock Mount Kit
- Q&A: Recommended Replacement Shock for a Dexter Axle 052-003-00
- Q&A: How to Measure Shock Length to Install Lippert Bolt-On Shock Mount Kit
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Most Popular Wheel Bearings
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: RV Sway Control, Stabilization, and Suspension Enhancement


Tom H.
11/17/2026
Just mounting brackets, did not come with shocks.