Where Does Tow Ready Trailer Wiring Harness 118270 Plug Into on a 2013 Buick Enclave

Updated 08/01/2014 | Published 07/31/2014

Question:

On my Buick Enclave there are three seperate plugs on the frame rail. One is for trailer brakes. I dont need that. The other two are four conductors each. Do these two plug into the one connector on this kit? In other words, two plugs from the car going into one connector on the kit?

asked by: Don

Helpful Expert Reply:

Trailer wiring harness # 118270 will plug into a single connector on your 2013 Buick Enclave. You will need to locate the vehicle’s connector located under the Enclave on the passenger's side. Look for an
opening to the right of the muffler. Reach up into opening to locate the grey connector. Disconnect the mating protective cover and discard. Connect the Enclave connector to the mating harness. All connector surfaces should be clean and free of dirt. Be careful not to damage the locking tabs and be sure that connectors are fully inserted with locking tabs in place.

I have included a picture from the instructions showing waht you should be looking for on your Enclave.

expert reply by: Michael H