Do You Need a Charge Wizard Pendant for a Progressive Dynamics PD9145AL Lithium Battery Converter?
Updated 10/04/2026 | Published 09/29/2026 >
Question:
I have a Intell-Power 9100 model PD9145AL converter in my rv. I have a 100amhr lithium battery. Do I need the charge wizard pendant to be able to charge my lithium battery. If so which one? Thanks
asked by: Rick
Expert Reply:
Hi Rick!
You do not need a Charge Wizard pendant to charge your 100Ah lithium battery with your Intell-Power 9100 model PD9145AL. It will charge lithium on it's own. The pendant is more of a monitoring system.
If you have the two stage version of PD9145AL you can use the Progressive Dynamics Charge Wizard pendant, part # PD92201, but it is not required for the converter to charge your battery. The pendant simply gives you more control over the charging modes.
Could you confirm the exact model number and charging voltage listed on the label of your converter so I can make sure you have the right setup?

Gary
10/3/2026
I have the pendant but honestly don't use it. I set my Converter to charge Lithium battery and have left it alone ever since. Thanks Gary


Dan G.
10/4/2026
The Progressive Dynamics lithium charger is “intelligent”, meaning it senses where it thinks the lithium battery is and decides whether it needs to charge or not. That’s great, except even their own engineering department will tell you that the charger sometimes gets “stuck” in the lower voltage mode, which will not charge the battery. The pendant allows you to know what the charger is doing, and if it gets “stuck” in the 13.5 volt maintain mode a simple press of the button will kick it up into the charge mode (14.4 volts). This seems to happen the most if you use your generator to charge your batteries. Nobody likes to run their generator for an hour or two and finally figure out nothing is happening. I found the pendant to be essential for this reason, a plus it’s not very expensive.
Product Page this Question was Asked From
Progressive Dynamics Converter Status Remote Pendant
- Accessories and Parts
- Power Converter
- Remote
- Progressive Dynamics
more information >
Continue Researching
- Q&A: Wiring Diagram for Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger
- Q&A: Will Progressive Dynamics 9300 Series RV Converter Charger Accept 6 Gauge Wire
- Q&A: Will 60 Amp Progressive Dynamics 9300 Converter Charger Replace PD9260
- Q&A: Is the Progressive Dynamics PD79RR Compatible with LiFePO4 Batteries?
- Q&A: Replacement Converter for Lithium Battery Upgrade
- Q&A: Best Lithium Converter Replacement Recommendation for for Replacing PD9140A
- Q&A: What is Difference Between 45 amp and 60 amp Progressive Dynamics Converter Chargers
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: 4-Step Guide to Installing RV Solar Power
- Article: Trailer Wiring Diagrams
- Article: Flat Towing Package for 1998-2006 Jeep Wrangler
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Article: How Much Solar Power Do I Need For My RV?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?


Rick
10/2/2026
Hi Heather, actually I figured it out. I have a solar charging system hooked up to the system. The charger was was seeing the solar input so it wasn't going to charge the battery. I did order a pendant from you so I can switch the charge on and off for the battery. Thanks