Trailer Hitch For A 1973 Ford F-250 With Chrome Step Bumper
Updated 09/16/2026 | Published 09/08/2026 >
Question:
I have a 1973 Ford F-250. I put a chrome step bumper on it and need a receiver hitch to pull my cattle trailer. Ive done a little research and know Ill probably have to drill. It had a hitch on it when I bought it so maybe the holes are already there. Do I need to measure the frame width so I can get the right hitch? Thanks
asked by: Victor C
Expert Reply:
Hi Victor!
It's possible your frame already has these mounting holes present, but even if you don't, I recommend the Curt Trailer Hitch Receiver - Custom Fit - Class V XD - 2" # C15300. This typically requires drilling, but I did include a picture showing the hole spacing to compare to the holes in your frame. It's rated up to 16,000 pounds towing and 2,400 pounds of tongue weight, so it will definitely handle anything your truck can.
And sweet truck! Which drivetrain do you have in it?
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class V XD - 2"
- Trailer Hitch
- For Towing
- Class V
- 2400 lbs TW
- 16000 lbs GTW
- 17000 lbs WD GTW
- 2 Inch Hitch
- 2400 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Dimensions for Curt Hitches 15300, 15511, 15318, 15319
- Q&A: What Gauge Wire Is Required On a 7-Way Connector
- Q&A: Distance From Rear Bolt Hole to Receiver Opening on B&W Heavy-Duty Trailer Hitch
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Front Hitch and TorkLift Tie Downs for a 2026 Ram 2500 Diesel w/a Factory Hitch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation on a Ford Full-Size Van
- Q&A: Class V Trailer Hitch Fit for 1993 Ford F350
- Q&A: How To Install A 7-Way Trailer Connector On a 1997 Ford F-350
- Q&A: Recommended No-Drill Trailer Hitch for a 1997 Dodge Ram 2500
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Troubleshooting Brake Controller Installations



Randy
9/16/2026
Yes, you probably have the narrow frame but you need to make sure. This fit my 1979 F250 fine but a bumper I ordered from another source did not so get it measured.