What is the Drop of the Carr Step?  

Hey Charles! The Curt TruTrack 2P Trunnion Weight Distribution System w/ Sway Control - 7-Hole Shank - 12K GTW #C75RJ will work great with your 2026 F-250 to pull a 25-30 ft RV. There isn't a kit with a 2.5" shank, but you can add Curt…

Hey Ken! Instead of worrying about fitment and a potential return I can give you some measurements so you can figure it out before ordering. The standard shank on the B&W Continuum Weight Distribution System #BW28FR is 11-3/8" from the…

Hey Rick, thanks for reaching out. The Mad Ramps Golf Cart Risers included with the #MR89RV kit are very straightforward to install. They bolt directly onto the existing ramp surfaces of your Mad Ramps system using the included hardware. Here are the…

Hey Rick! For your 2026 Ford F-350 Super Duty with 4WD, you will go with Hellwig Adjustable Big Wig Rear Anti-Sway Bar - 1-5/16" Diameter #HE94FR. This model is intended for 4-wheel drive models that sit at stock height. The Hellwig Adjustable…

Hey Kevin, thanks for reaching out. Congrats on the new F150 and the Escape 5th wheel! I love that camper too its just the right size. You’re on the right track. Since the F150 doesn’t offer the third brake light camera like the Super Duty trucks,…

Hey Jon, I have a solution for you but I would not recommend the Andersen Weight Distribution system part #AN33VR for your 2025 Brinkley Z Air 297. What we have found is that the Andersen system does a decent job with lighter weight trailers but for…

Hi Jim; for your 2025 Ford F-350 I recommend the B&W Turnoverball Underbed Gooseneck Trailer Hitch #BW73FR. The Turnoverball allows you to store the hitch ball upside down when not in use for full bed access. It also uses a square base so it…

Blane, what you're looking for is the 7-Leaf Double-Eye Spring for 8,000-lb Trailer Axles #DX74XR. This spring has a 4k capacity, will work with 8k axles, has 1 3/4" wide leaves. You'll notice that these springs are a bit shorter, but…

I've contacted Brightway, who forwarded me a copy of the instructions they include with the #BRW77FR switch mode charger. I've provided a clip showing the instructions for you.

The bolt sizes are commonly M12-1.25x40 and M10-1.25x35. If you are looking at the Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2" #65075 the hardware comes with it and you can find the specs on the parts in the instruction manual…

I'm not sure how to find out the age of your setup, but when I passed your photos along to my contact at Equal-i-zer he said that all you need to do for the upgraded system is swap out your 12K head unit for the 14K #EQ90-02-1400. Since your…

If you are going to install two of the MORryde X-Factor Crossmembers #MR33WR on your tandem axle trailer Alan you would want to install them on the front and rear hangers. You can install a third one if you want on the middle hanger as well for even…