Can Main Bracket On Timbren Axle-Less Be Reversed
Updated 09/02/2026 | Published 08/27/2026 >
Question:
Can the main bracket that attaches to the frame be reversed and welded to the side of the trailer frame? No accesson the outsdie for bolts.
asked by: Steve A
Expert Reply:
Hey Steve! You can weld the Timbren Axle-Less Suspension # ASR35HDS02 to the trailer frame if you don't have access for the mounting bolts. However, you can't reverse the brackets to put the taller mounting plate on the inside of the frame. Doing so would put the suspension arms in the wrong orientation since they're designed to trail toward the rear of the trailer. Welding them in the standard orientation is the only option.
What kind of trailer are you working on?
Product Page this Question was Asked From
Timbren Axle-Less Trailer Suspension - Heavy Duty - Long Spindle - 4" Lift - 5 Bolt - 3.5K
- Trailer Axles
- Rubber Spring Suspension
- Standard Grade
- No Hubs
- 3500 lbs
- Spindles Only
- Universal Fit
- Lift - 4 Inch
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Timbren Axle-Less Trailer Suspension Compatibility with Jeep 5 on 5 Bolt Pattern
- Q&A: What Hub/Drums Are Recommended for Timbren 3,500 lb Axle Less System
- Q&A: What Is The Difference Between Timbren xle-Less Trailer Suspension T54KV And TASR5200S03?
- Q&A: Difference Between Timbren Axless Suspension Systems T54KV and T99GR
- Q&A: Electric Brakes with Parking Brake Feature for Timbren 3.5K 4" Lift Axle-Less System
- Q&A: Recommendations For Upgrading to Timbren Heavy Duty Axle-Less Trailer Suspension
- Q&A: What Parts Do I Need to Install the Timbren Axle-Less Trailer Suspension # T99GR?
- Article: Where to Position the Trailer Axle?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Raise Your Travel Trailer Height
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Lighting Requirements



Steve A.
9/2/2026
Robin - Thanks for the reply and sorry for the typos in the initial question. Obviously, the suspension can't be reversed but is there an engineering reason why the vertical bracket couldn't be cut off then rewelded to the inside of the frame. My tear drop camper body extends below the outside of the 2x3 frame so there is no access for bolts or welding without cutting into the body. This might be a better question for Timbren engineers but thought I'd check with you guys. Thanks!