What MORryde X-Factor Crossmember Goes with My CRE3000 Equalizers?
Updated 08/17/2026 | Published 08/10/2026
Products Featured in This Question
Question:
I would like to know which MORryde X-Factor Cross memberMR33WR or MR99ZR I need for my tandem axle travel trailer. My RV axles have overslung leaf springsnot sure that matters and I have the MORryde CRE3000 suspension installed. If I need to, I can send a picture of the leaf spring hangers. Thank you, Jason
asked by: Jason S
Expert Reply:
Hey Jason,
Because you already have the MORryde CRE3000 installed on your trailer, you'll need the MORryde X-Factor Crossmember for Standard Frame Hangers part # MR33WR. The # MR33WR is specifically for the MORryde CRE, SRE, or stock suspension system which makes it the correct one for your trailer. The overslung leaf springs won't affect anything with the crossmember either.
One thing to check before ordering is clearance. The MR33WR adjusts from approximately 61"–79-1/2", and you'll want to make sure tanks, plumbing, gas lines, etc. don't interfere with the crossmember. If something is in the way, MORryde offers the # MR43WR drop-down adapter, which provides additional clearance.
Are you experiencing any damage to the welds or hangers on your camper?
(click to enlarge)
Product Page this Question was Asked From
MORryde X-Factor Crossmember for Standard Frame Hangers
- Accessories and Parts
- Trailer Suspension Parts
- Crossmember
- MORryde
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: GE Profile RV Cooktop Cover - 24" - Tempered Glass
- Q&A: Does the X-Factor Crossmember for Standard Frame Hangers Require Longer Suspension Bolts?
- Q&A: Which Hangers Should MORryde X-Factor Crossmembers Install On
- Q&A: Which MORryde X-Factor Can be Used with CRE3000 MORryde Equalizer Kit 2022 Grand Design Imagine
- Q&A: MORryde X-Factor Crossmember for a 2019 Cruiser RV Stryker ST-3116
- Q&A: What is the Difference Between the MORryde CRE3000 and AllTrek 4000 Suspension Kits
- Q&A: Can I Install Just One MORryde X-Factor Crossmember Or Do I Need All Three?
- Q&A: Can MORryde X-Factor Crossmembers Be Used With Roadmaster Comfort Ride System?
- Article: Trailer Wiring Diagrams
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: RV Propane 101: How Does My RV's Propane System Work?
Adam
8/17/2026
Standards work great as long as there is no dump plumbing in the way of the spring hangers that you are wanting to install the cross member on I put the standard on the rear to start, when I go to do the middle I’ll need the drop brackets to clear the gray water dump pipe that is exposed below the under belly. Super easy installation and a great piece of mind going down the road. Hope this helps and happy camping!!