Will The Dexter Idler Hub DX45BR Work With A 10" Kodiak Slip-On Rotor?
Updated 08/03/2026 | Published 08/01/2026
Products Featured in This Question
Question:
Hi im am looking to buy your idler hub DX45BR, will this work with a 10 inch kodiak slip on rotor? Also I am wanting to buy a triple lip.seal dx49cr, for this idler, will this work for this as well?
asked by: Allen c
Expert Reply:
Hey Allen. Yes, the Dexter Idler Hub # DX45BR will work with the 10" Kodiak slip-on rotors, provided the rotor has the same 5 on 4-1/2" bolt pattern.
The Grease Seal Kit # DX49CR will fit the # DX45BR hubs. You'll just want to make sure the 1.719" ID matches up with your spindles. That is the standard seal size for a 3,500 lb axle.
Do you know the weight capacity of each axle?
(click to enlarge)
Product Page this Question was Asked From
Trailer Idler Hub Assembly for 4,200-lb Axles - 5 on 4-1/2 - Galvanized
- Trailer Hubs and Drums
- Idler Hub
- Standard
- L68149 / L68149
- Marine Grade
- For 4200 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: Looking To Replace Tie Down Engineering Brake Pads And Rotors
- Q&A: Troubleshooting Trailer Tire Wear on the Outside Edge of the Tire
- Q&A: What Will Cause Excessive Wear on the Outside of the Tire on a Single Axle Cargo Trailer
- Q&A: Recommended Non-Brake Replacement for Dexter 8-243 Hub/Drum
- Q&A: Can Velit Diesel RV Heater Heat 288 sq ft Snowmobile Trailer
- Q&A: Replacement for a TDE Model LP7000 Brake Actuator
- Q&A: Replacement Trailer Idler Hub That Uses L68149 Inner and Outer Bearings and 5-on-4-1/2 Bolt Pattern
- Article: Most Popular Wheel Bearings
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)