Low Profile Locking Hitch Pin for a 2018 Mercedes Sprinter 2500 Factory Hitch
Updated 07/23/2026 | Published 07/19/2026 >
Question:
I have a 2018 Mercedes sprinter can 2500 with a factory installed 2 inch receiver that I’m looking for a locking hitch pin for the wiring plug housing is very close to the receiver so finding a locking hitch pin has been difficult can you direct me to one that will fit the tight space? Leslie
asked by: leslie A
Expert Reply:
Hi Leslie,
I completely understand the challenge. I looked at some photos of the factory hitch on your 2018 Mercedes Sprinter 2500, and Mercedes definitely tucks that wiring plug in close to the receiver, which can make finding a locking hitch pin a little tricky.
The lowest profile locking hitch pin we carry for a 2 inch receiver is the Curt Trailer Hitch Receiver Lock, part # C23517. It has one of the shortest locking heads available, so it's usually the best option when clearance is tight. Another trick that often works is installing the pin from the passenger side instead of the driver's side so the lock ends up on the side opposite the wiring plug.
Before I tell you this one is a sure fit, could you let me know about how much space you have between the receiver and the wiring plug? Also, is the issue that the pin itself is too long, or is it the locking head that's contacting the plug housing?
Out of curiosity, what do you usually have on the back of your Sprinter, a hitch cover, a bike rack, or a cargo carrier?
Product Page this Question was Asked From
Curt Trailer Hitch Receiver Lock - 1-1/4" and 2" Hitches - Stainless Steel
- Trailer Hitch Lock
- Standard Pin Lock
- Keyed Unique
- Stainless Steel
- Fits 1-1/4 and 2 Inch Hitch
- Fits 1-1/4 Inch Hitch
- Fits 2 Inch Hitch
- Flush Pin
- 2-13/16 Inch Span
- CURT
more information >
Continue Researching
- Q&A: Can Curt Quick Pin Coupler Fit on 2014 Lance 1985
- Q&A: Is the Curt Cam Buckle Stabilizing Strap Required for Curt 1 1/4" Receivers?
- Q&A: Recommended Hitch for a 2024 Toyota Camry
- Q&A: Tightest 2-1/2" to 2" Receiver Reducer Sleeve with the Least Movement
- Q&A: Recommended Locking Hitch Pin for a Kuat Transfer V2 Bike Rack
- Q&A: How to Easily Determine Trailer Wheel Bolt Pattern
- Q&A: Will the eTrailer Hitch for a 2020 Honda CR-V Block the Hands Free Lift-Gate Sensor
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: My Trailer Hitch Doesn't Fit
- Article: Steel vs. Aluminum Ball Mounts
- Article: Which Hitches are Made in the USA
- Article: How to Measure for Trailer Hitch Drop
- Article: Ram Trailer Tow Prep Package


Leslie A.
7/23/2026
Can’t install from the other side as there is no room to place the locking and to the pin. I removed the four screws holding the wiring plug in place and pulled the plug out then had room to install the hitch pin that came with the rack attach from 1- up. Then re installed it. Kind of a pain because to unlock the pin I have to remove the plug again a lock that is accessed off the side instead of the end may be better.