Best Towing Mirrors For 2017 Forest River/Mercedes-Benz Sprinter 3500 Class C RV
Updated 07/06/2026 | Published 06/26/2026 >
Question:
Looking for tow mirrors or extentions for my 2017 forest river forester class c mb 3500 chassis thanks
asked by: Roger O
Expert Reply:
Hey Roger, welcome back! For your 2017 Forest River Class C on the Mercedes-Benz Sprinter 3500 chassis, I'd recommend the CIPA Universal Clamp-On Towing Mirrors # CM11980-2.
These clamp securely to the factory mirrors and add a 7-1/2" wide x 4-5/8" tall mirror surface for a much better view down the sides of your coach. They also telescope out for additional visibility, so you can fine-tune the view depending on what you're towing. Since there aren't custom-fit towing mirrors made for the Sprinter 3500, these universal CIPA mirrors are one of the best options for improving rearward visibility without permanently modifying your factory mirrors.
Are you hauling a trailer with your sprinter? What kind?

Roger H.
6/30/2026
The mirrors do work actually well. I use them on my 2024 Toyota 4 runner. Follow the instructions, tighten them with your fingers still you can’t. Drive a little bit, stop and check, tighten them again if they have loosened. Then you’re good to go. Check again when you stop for a break. Bumpy roads you may want to check often. I have only lost one in the 3-4 years I have been using them. They fit well and do the job. Roger H. Orangevale Ca


Allenf
6/30/2026
I've had these for a couple of years and lost one twice. If they aren't put on just so, tightened, and retightened as you travel, you'll lose one or both. I found some that use a strap that's much better and easier to put on and take off.

Scott C.
6/30/2026
I bought a pair for my Chevy Express van. I would say similar things that others have posted here...make sure the connectors are TIGHT. I lost one (fortunately not damaged) when a semi going the opposite way on a 65mph two lane road "sucked" the driver's side mirror off my van. Had to go quite a way down the road before I could turn my van+trailer combo around to go see if I could find the mirror and it was ok. You need about 1/4" between your vehicle's mirror housing and it's mirror to fit the tow mirror clamps. Mirror coverage is good, you can orient the glass either vertically or horizontally. Same with the mounting arm, though I would say how you mount them to your vehicle mirror housing is somewhat dependent on the shape and design of that housing.


Todd G.
6/30/2026
They worked good the first couple of times, although I must have failed at tightening them down because I lost one on the way home earlier this spring.
Product Page this Question was Asked From
CIPA Universal Towing Mirrors - Clamp On - Qty 2
- Towing Mirrors
- Clamp-On Mirror
- Manual
- Pair of Mirrors
- Universal Fit
- Fits Driver and Passenger Side
- CIPA
more information >
Continue Researching
- Shop: Towing Mirrors
- Shop: CIPA Universal Towing Mirrors - Clamp On - Qty 2
- Q&A: Weight Distribution Recommendation for 2026 Jayco Feather 19MRK
- Q&A: Choosing Between the CIPA and K-Source Universal Towing Mirrors for a 2008 Ford Expedition
- Q&A: Towing Mirrors for 2010 Toyota Tundra Platinum
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Warranty Policy for the Benton Cargo Carrier part # B38VR?
- Q&A: Comparing the Andersen Weight Distribution Systems To Friction Bar Systems
- Q&A: Picking Out Andersen Weight Distribution System And Adjusting It For A Level Truck And Trailer
- Q&A: Availability of Flat Mount Coupler With 5" Mounting Hole Spacing
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Determining Trailer Tongue Weight
- Article: The Best Towing Mirrors
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Which Sway Control Hitch is Right For Your Trailer?






Roger O.
6/29/2026
My vehicle is not on the fitment list thou