Distance From Hitch Pin Hole To Back of etrailer High-Low Adapter In Rise Position

Published 06/22/2026

Question:

What is the distance from the receiver pin to the fwd end of the riser? I need to know if it will clear the fiberglass rear cap

asked by: David H

Expert Reply:

Hi David; the distance from the center of the hitch pin hole to the back of the section where the receiver mounts on the # e52ZV is 7-3/8". There is a bit of an overlap, so with the receiver mounted that will reduce this measurement by 1-/4" if you have it all the way at the top. From the center of the hitch pin hole that portion will stick up 8".

I added some additional measurements in the diagram below, it should be enough for you to determine if it will clear.

expert reply by: Robin H