Extra Wire Needed to Install ETBC7 Brake Controller Install Kit on 30 Foot Long RV
Updated 06/22/2026 | Published 06/18/2026 >
Products Featured in This Question
Question:
I’m currently looking at wiring my Class C RV and have to use the ETBC 7 kit. My RV is 30ft but the 10g jacket wire is only 25ft. Do you offer this kit with a longer jacket wire? Like a kit with 40ft jacket wire?
asked by: Kelly H
Expert Reply:
Hey Kelly, we used to have a version of the # ETBC7 that had extended wiring but we don't have it currently so best option would be to order a length of 10 gauge wire like part # 10-2-1 that we sell by the foot to match the length of your RV or the length of the wire that you would need. This is doubled bonded 10 gauge wire which means it's two 10 gauge wires bonded together. Typically an extra 10 foot is needed but for an RV like yours it would probably be more than that.
We also have 10 gauge wire as a single wire with the part # 10-1-1.
What kind of brake controller do you have?

Tom
6/19/2026
I recently installed the ETC7 on a Ford Maverick hybrid all went well, except connecting the last power wire from the brake pedal to the brake controller. It was impossible for me to do. Luckily I found an installer and it was worth every penny of the $40 it cost. Otherwise there is no way. That kid otherwise there is no way in my opinion that the wiring in that kit would be enough for a 30 foot RV.


Evan
6/20/2026
Kit was pretty good. Easy to install and you could easily extend it. Only weakness was the actual 7 way plug. Mine only lasted a few months before it completely corroded out and I had to replace it. It was never in salt, not sure what happened but it was junk.


Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Thule T2 Pro XTR Bike Rack for 2 Bikes - 2" Hitches - Wheel Mount
- Shop: Trailer Hitch
- Shop: Hollywood Racks Sport Rider SE Bike Rack for 2 Electric Bikes - 2" Hitches - Frame Mount
- Search Results: 13611
- Search Results: 76432
- Q&A: 4-Flat Wiring Harness For 2026 Hyundai Tucson Hybrid
- Search Results: airlift 1000
- Search Results: 118884
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Search Results: 40 amp breaker
- Search Results: 118255
- Search Results: 6 bike rack
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Oris Trailer Hitch with Detachable Hitch Receiver - Custom Fit - 2"
- Q&A: Trailer Hitch Recommendation for 2017 Jeep Grand Cherokee Laredo
- Video: DIY Install Curt Hitch Receiver - 2023 Volvo XC40 Recharge
- Video: Curt Class III Trailer Hitch Step-By-Step Install - 2024 Toyota RAV4 Hybrid
- Q&A: Should Undercoat on Frame Be Scraped Away Before Installing Hitch
- Video: How to Install the etrailer Hitch Receiver - 2022 Lincoln Nautilus
- Video: DIY Installation Curt T-Connector Wiring Harness - 2022 Lincoln Nautilus
- Video: Curt T-Connector Vehicle Wiring Harness Installation - 2021 Lincoln Nautilus
- Video: Trailer Wiring Harness Installation - 2011 Toyota Corolla
- Video: 2009 Toyota Corolla Curt Trailer Hitch Receiver: Complete Installation
- Q&A: 4-Way to 7-Way Adapter Recommendation for Installing Curt Echo Mobile Brake Controller
- Q&A: Where to Run Power Wire for 4-Way and 7-Way on 2022 Jeep Grand Cherokee WL
- Q&A: Wire Gauge for 12V Power Feed on 7-Way on 2016 Ford F-150
- Q&A: What is the Wire Gauge on the 6-Pole Square Trailer Wiring Connector # 37995, for a 1993 Saturn SW2
- Shop: Trailer Wiring


Kelly H.
6/18/2026
I have not purchased a brake controller yet. What one would you recommend? My RV from what I can tell does not have pre wiring for a 7 plug. It only has a 4 plug