Recommended 5-3/4" Diameter LED Backup Light
Updated 06/04/2026 | Published 05/28/2026 >
Products Featured in This Question
Question:
I am looking for a white backup light similar style to the existing tail light on my Rockwood camper. It is an Optronics 5-3/4” diameter surface mount that is about 1-1/4 tall. There is no rubber ring around it and it is not flush with the surface of the camper. I would like it as bright as possible and plan on mounting one near each tail light. Thank you.
asked by: Mark M
Expert Reply:
Hey Mark, thanks for the information! The LED Backup Light w/ Flange for Trucks or Trailers item # BUL11CBX is going to be the closest option I have to your specifications. This is a 5-3/4" diameter LED back up light that mounts in a 4-1/2" diameter cutout. It has three mounting holes spaced 4-7/8" apart center on center.
You can use the Right Angle 2-Wire Pigtail item # A49PB or the 2-Wire Pigtail item # A45CB to complete the installation.
Do you see any part numbers on your Optronics light?
You can add this information, along with any other questions you have, where it says Add Comment.
Product Page this Question was Asked From
LED Backup Light w/ Flange for Trucks or Trailers - Submersible - 10 Diodes - Round - Clear Lens
- Trailer Lights
- Tail Lights
- Backup
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 5-3/4 Inch Diameter
- White
- Optronics
more information >
Continue Researching
- Q&A: Replacement Reverse Light for Ranger z521 Boat Trailer
- Q&A: Optronics Mini Red LED Clearance or Side Marker Light MCL131CR3B
- Q&A: Recommended Disc Brake Pads for a Dexter 89-3 Caliper
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Door Hinge for 2001 Exiss Horse Trailer
- Q&A: Replacement Lippert Control Box for 140-1227 Box
- Q&A: How to Get Separate Turn Signals and Brake Lights to Work on a Trailer
- Q&A: Best Replacement For Norcold N611 RV Refrigerator
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Tire Sizing
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)



Mark M.
6/4/2026
Very industrial looking and requires a large hole. I’d prefer a surface mount that can have a smaller hole to accommodate wiring. I found these numbers on my tail lights after lots of searching: SAE AS2T216L 17 DOT I also found some lights on your site that don’t match but would work. I’m not sure which require a grommet or can be used with or without a grommet and am not interested in those with grommets. What would be brightest and best for backup behind a travel trailer using a backup camera? BUL11CMB PE44AR 328-007-60WE UCL41CB BUL101CB BUL06CB PE44AR BUL003CB BUL43CB BUL35CB Thanks a lot for your help! Mark