How is the Rackem Wheel Chock # RA-17 Removable
Updated 07/16/2014 | Published 07/14/2014
Question:
How does the chock attach to the bracket..are they wing nuts or wing bolt.are they studs or do they bolt...any pictures of the underside attaching would be extremely helpful
asked by: Jim
Helpful Expert Reply:
The Rack'em wheel chock # RA-17 is actually 2 separate pieces. The base will be permanently installed to the trailer floor. The chock part is removable. It uses 2 wing nuts, included, and the bottom of the chock has pins that fit in special slots on the top of the base.
I made a video showing you all of this that will appear on this page.
Product Page this Question was Asked From
Rack'Em Manufacturing Removable Wheel Chock
- Wheel Chocks
- Wheel Chock
- Motorcycle
- Steel
- 1 Chock
- Gray
- RackEm
more information >
Continue Researching
- Q&A: Wheel Chock Recommendation for Harley in Trailer
- Q&A: Does The Fas-Top Traveler Roll-up Tonneau & Soft Truck Topper Combo Fit 2022 Ram 2500 Mega Cab?
- Q&A: Are There RV Cameras Compatible With The GM Infotainment System
- Q&A: Is There a Replacement for the Lippert 2 Inch Latch Coupler Repair Kit 678750
- Q&A: Bolt Size Recommended For Channel Style Tongue Trailer Coupler Installation
- Q&A: Difference Between ST225/75D15 and ST225/75R15 Trailer Tire
- Q&A: Do You Have the Instructions and User Manual for the Advent Air Low Profile RV Air Conditioner?
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Can You Flat Tow a 2025 Chevy Silverado 1500?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How (and Where) to Connect an RV Propane Grill
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Big Truck Big RV