What is the Distance from the Hitch Pin Hole to the Safety Chain Loop Bracket?
Updated 05/21/2026 | Published 05/16/2026 >
Products Featured in This Question
Question:
Hi, Quick question on your hitch e75ZR for my 2021 Toyota Highlander. My hitch rail takes bolts instead of the pin. Is there enough room for the heads of the bolts next to the safety chain plates, they look close to the holes? Thanks!
asked by: William S
Expert Reply:
Hi William,
I went out to the warehouse to measure the hitch receiver tube and there is about 3/4" of space from the center of the hitch pin hole to the safety chain bracket loop plate. I recommend measuring the head of the bolt that is used for your hitch rail to make sure that it will fit within that 3/4" space.
What hitch accessory are you planning on using with the hitch?
Product Page this Question was Asked From
etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Hitch For A 2021 Toyota Highlander XSE
- Q&A: Differences Between Coil Springs for 2016 Toyota Highlander
- Q&A: What Trailer Wiring do I Need for My 2020 Highlander without Factory Tow, with Connectors?
- Q&A: How Long Does The TowSmart Hitch TS56VR Take To Install On A 2023 Toyota Highlander?
- Q&A: Best Hitch for a 2022 Toyota Highlander
- Q&A: Recommended Trailer Hitch and Wiring for a 2023 Toyota Highlander
- Q&A: Plug In Trailer Wiring Harness For A 2024 Toyota Highlander XLE
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Hitch Installation Tips
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller Installation: Starting from Scratch
- Article: 5 Tips to Confidently Choose Your Weight Distribution Hitch
- Article: How to Measure for Trailer Hitch Drop


William S.
5/20/2026
I'm using a dirt bike carrier. I received the hitch today and the bolts I'm using have a 22mm head. They fit flat without scraping the angled safety chain plates. All good!