Will Upgrading My Trailer Hitch Increase The Towing Capacity Of My 2024 Ford F-250?
Updated 05/08/2026 | Published 04/30/2026 >
Products Featured in This Question
Question:
The factory hitch weight for my 2024 f250 is 1660lbs with a max trailer weight of 16600lbs. the trailer i am looking at is 9750lbs and tongue weight of 1400lbs. once i load the trailer, I am sure i will be close to or just over the hitch weight limit of 1660. I plan to use a WDH. Should I upgrade the receiver too? Will this increase my tongue weight capacity to what the curt receiver is? Will a WDH take enough weight off the hitch?
asked by: Brett B
Expert Reply:
Hey Brett, thanks for reaching out. You’re looking at it the right way, but that 1,660 lb number is just the weight carrying rating, not the whole picture. Once you bring a weight distribution hitch into the mix, your factory receiver is rated higher in weight distribution mode, and on those F-250s it’s usually up in the 2,000+ lb tongue weight range. So even if your trailer ends up a little over that 1,660 once it’s loaded, you’re still typically within what the truck is designed to handle with a properly set up WDH.
The WDH doesn’t take weight off the hitch, it just spreads it out across the truck and trailer so everything carries it better.
As far as upgrading the receiver, you’re not really gaining anything there. The factory hitch on a 2024 F-250 is already built to match the truck’s ratings, and those ratings are what ultimately limit you, not the sticker on an aftermarket hitch. Get a good WDH that’s sized correctly and dial it in, and that’s what’s going to make the setup work the way it should.
As far as a good WDH for that trailer, here is what I recommend:
- Blue Ox SwayPro Weight Distribution w/ Sway Control for 2-1/2" Hitch - 20K GTW, 2K TW # BXW2000
This is for trailers with a tongue weight between 1,500 and 2,000 lbs so you'll be right within that range. Just make sure you have room on the frame for the brackets. They need to be about 29" back from the hitch ball. Its a super solid, easy to install system. Definitely one of my go-to WD hitches.
What kind of trailer are you hauling?
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class V Commercial Duty - 2-1/2"
- Trailer Hitch
- For Towing
- Class V
- 2700 lbs TW
- 20000 lbs GTW
- 20000 lbs WD GTW
- 2-1/2 Inch Hitch
- 2700 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Where do the Vertical Mounts on the Curt Hitch C15802? What is the Inside to Inside Measurement?
- Q&A: Dimensions of Curt Trailer Hitch Receiver 2-1/2 Inch # 15802
- Q&A: Will Curt Clevis Hook Attach to Curt Class V Hitch?
- Q&A: Picture of Curt Hitch # C15802 Installed On Ford Truck
- Q&A: 2006 Fleetwood Pace Arrow 36D Ladder Replacement
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Can Front Runner Propane Tank Holder Secure Tanks On It's Side
- Q&A: How Does The B&W Heavy-Duty Trailer Hitch Receiver Look On The 2017 Ford F-350 Super Duty
- Article: Most Popular Wheel Bearings
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Choose the Right Trailer Hitch Class
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Hitch Receiver Sizes
- Article: Gooseneck Trailer Hitch Information and Review


Brett B.
5/6/2026
Thanks Jesse. I appreciate the response and exactly what I wanted to hear. The trailer is a 38ft RV with dry weight ratings like I mentioned above. With a trailer that long I was looking at Equalizer WDH. I love that the BlueOx is adjustable though. I read that the Equalizer would handle any sway better. Which one do you think would be better? I’m currently pulling a 35ft Rv with an equalizer