Replacement Disc Brake Kit for a Myco Boat Trailer w/a 6 on 5-1/2 Lug Nut Pattern

Question

Question:

I have a 2006 Myco trailer pulling a 38 foot Formula offshore powerboat. Boat and trailer about 12,500. The boat has DeeMaxx 6 lug now. Would these DE58YR work on my trailer? It appears the DE58YR are a complete set and include everything disc, hubs, races, bearings, and for a complete swap of what I currently have, is that correct. I have 2 disc axles and one axel just holds wheels.

asked by: Kenny

0

Brake Caliper
(click to enlarge)

Disc Brake Hub
(click to enlarge)

Expert Reply:

Hey Kenny, thanks for the pictures. The DeeMaxx Disc Brakes item # DE58YR do come with everything you need to swap out an existing disc brake setup but I do not have anyway of knowing what size spindles your boat trailer currently has to confirm it'll fit.

What you'll need to do is pull one of your hubs and check the part numbers stamped into the sides of the inner and outer bearing. This will tell me what size spindle your trailer has. The DeeMaxx Disc Brakes item # DE58YR uses an inner bearing item # 25580 and a outer bearing item # 15123.

If they do not have numbers stamped into the sides of your bearings, you'll need to measure your spindles using a digital caliper like item # PTW80157. I'll need the C and D dimensions shown in the diagram below.

You can add this information, along with any other questions you have, where it says Add Comment.

expert reply by: Jerred H

0

Spindle Measurement Diagram
(click to enlarge)

Kenny

2/11/2026

Thank you Jerred, thank you for your response. My trailer is currently shrink-wrapped but I contacted Myco and I received a spec sheet from the original build in 2006. I can e-mail that to you if you can give me a correct e-mail address. However it does list the inner bearing as #25580 however, the outer bearing number from my spec sheet says #LM67048 could that be correct? /Users/kennethwithrow/Desktop/IMG_0193.jpeg

Jerred H.

2/12/2026

@Kenny You're welcome! Thank you so much for getting that information. Both the item # LM67048 and item # 15123 outer bearings have the same 1.250" inner diameter, which means the DeeMaxx Disc Brakes item # DE58YR are exactly what you need. These are sold as a pair so you'll need two sets.

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 6

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 7

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 8

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Replacement Disc Brake Kit for a Myco Boat Trailer w/a 6 on 5-1/2 Lug Nut Pattern

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching