Where to Install Redline 2-Piece Polypropylene Trailer Vent # HMAV2-AVT2
Updated 07/02/2014 | Published 07/01/2014
Products Featured in This Question
Question:
where to put them in the bottom or up the trailer, in front or rear É
asked by: Luc L
Helpful Expert Reply:
The Redline 2-Piece Polypropylene Trailer Vent # HMAV2-AVT2 can be installed in any convenient location on your enclosed trailer where you have or can make a 3-inch diameter hole. These vents will work best when used in multiples, with some near the ceiling and some near the floor, to allow cooler air to enter through the lower vents and hotter air to exit through the upper vents.
I recommend you use a sealant for installation, such as silicone caulk or Silicone Sealant # 0160297. You'll also need to supply 9 installation screws per vent, such as either # 31071 for sheet metal or # 30587 for wood.
Product Page this Question was Asked From
2-Piece Exterior Wall Vent for Enclosed Trailers - Polypropylene - 3" Diameter Hole - Black
- RV Vents and Fans
- Vent
- Wall Vent
- No Fan
- Plastic
- Black
- Redline
more information >
Continue Researching
- Q&A: Side Wall Vent Recommendation for an Enclosed Trailer for Maximum Air Flow
- Q&A: Can I Mount the Redarc Tow-Pro Link to a Trailer Instead of Under the Vehicle?
- Q&A: Replacement Door for a Dometic DMC74FR Water Heater
- Q&A: Will the Van Windows Direct Awning Van Bunk Window VW74FR Fit a 2023 Ram ProMaster 3500 EXT?
- Q&A: Does the 2-Piece Polypropylene Trailer Vent have to Be Installed Facing a Certain Direction
- Q&A: Options to Vent a Storage Compartment on an RV
- Q&A: Parts Needed To Flat Tow 2008 Jeep Wrangler
- Article: How to Replace or Install an RV Roof Vent
- Article: Trailer Lighting Requirements
- Article: Can You Flat Tow a MINI Cooper?
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Wiring Diagrams