Could I Install The Lippert Manual Pull-Out Steps On My 2025 Ford Transit?
Updated 02/10/2026 | Published 01/23/2026 >
Question:
Does this step fit on the Ford Transit cargo van 2025 for the side and the rear doors?
asked by: Anna
Expert Reply:
Hey Anna,
Technically you could install the Lippert Manual Pull-Out Step # LC432678 onto your 2025 Ford Transit T250, however it would not be a simple bolt on installation. These are meant for RVs or travel trailers that have pre drilled holes for these steps for easy installation. For your Transit you would have to measure and drill out holes in order to install this.
The mounting bracket itself is 25-3/4" wide x 6-3/4" tall x 5-3/4" deep. The actual mounting hole dimensions are 24" x 4" (see attached photo). So these could install onto your Transit but you would need to measure and drill out the mounting holes.
What are you using that Transit for currently?
Product Page this Question was Asked From
Lippert Manual Pull-Out Step for RVs - Single - 7" Drop - 24-1/4" Wide - Steel - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 25-3/4 Inch Wide
- 1 Step
- 7 Inch Drop/Rise
- Steel
- Lippert
more information >
Continue Researching
- Q&A: Which Folding Handrail Is the Strongest? A Stainless Steel or Aluminum One?
- Q&A: What Comes Included With The Timbren Silent Ride Suspension for Tandem Axles TSR7000T04?
- Q&A: Will Single Step LC432678 Fit 2022 nuCamp 320
- Q&A: Is Kwikee Electric RV Step Frame Available As Replacement Part
- Q&A: Can Little Red Campfire Connect to RV Propane Source
- Q&A: Replacement Bearings for Dexter 8-208 Hub
- Q&A: What is the Correct Hub Replacement for Dexter 8-208?
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Motorhome Steps
- Article: The Best Electric Trailer Jacks of 2025
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Raise Your Travel Trailer Height
- Article: Double-Eye Trailer Suspension System Review
- Article: Where to Position the Trailer Axle?



Nick S.
2/10/2026
Hey Anna, how did your measurements go for mounting the Lippert pull-out step on your Transit? Were you able to get it lined up for the side or rear doors? Your update could make it easier for others working on similar vans.