Looking To Add A 110v Outlet To My 2022 Ram ProMaster
Updated 12/29/2025 | Published 12/08/2025
Question:
HI, I want to install a 110V outlet on the outside of my promaster van. Can you please send me a link to the required parts I need to do this. Many thanks! Ken
asked by: Kenneth D
Expert Reply:
Hey Kenneth,
If you are just wanting an outlet on that ProMaster for when you are able to plug in at a campsite or at home I recommend the # 329-GCP2. If you are looking to add this outlet and be able to use it without being plugged into a campsite you would need to pair it with an inverter. I recommend the Go Power # 34282692 to pair with that allowing you to use the outlet even when you are not plugged in.
Is that ProMaster renovated into a camper van?
Product Page this Question was Asked From
NOCO AC Port Plug with Dual Extension Cords - 18" Long
- Accessories and Parts
- Battery Charger
- Vehicle Heaters
- Plugs and Sockets
- NOCO
more information >
Continue Researching
- Shop: NOCO AC Port Plug with Dual Extension Cords - 18" Long
- Q&A: Will P&F Products H-Channel Frame for Enclosed Trailers Fit Over 1 inch Channel
- Q&A: Is The Power Mountain Jack A Single Or Dual Piston Jack?
- Q&A: Replacement Inner Tube Gooseneck Coupler 4" Diameter For BullDog Bx1 25k
- Q&A: Replacement RV Stove for Suburban SRNA3LBSE
- Q&A: Adding a Battery on an Enclosed Trailer to Power Interior Lights
- Q&A: Can I Mount Multiple Pieces Of E-track To Make An 18 Feet Strip
- Q&A: Do Half Moon Trailer Vents Need to be Installed Facing Down or Back
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Article: Trailer Wiring Diagrams
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Measure for Motorhome Steps
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
Nick S.
12/29/2025
Hey Kenneth, how did things go with adding the 110V outlet on your ProMaster using the NOCO plug and Go Power inverter? Your update could make it easier for others planning a similar setup.