Looking for Trailer Grease Seal that Has Outer Diameter 2.33 inch and Inner 1.675 inch
Updated 12/01/2025 | Published 10/31/2025
Question:
I am looking for a trailer grease seal. OD is 2.33 inches, ID is 1.675 inches. Its odd in that the seal is not in plane. It is offset 0.25 inches sticks out 0.25 inches beyond the hub. Similar to seal 168233, but offset 0.25 inches.
asked by: Dane G
0
Expert Reply:
Hey Dane, the only seal we offer that matches the dimensions you need is the part # 168233 that you referenced. While this would install flush in your hub it wouldn't be an issue compared to what you have now. Your current seal being wider or sticking out further would not be a problem.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Double Lip
- 1.69 Inch I.D.
- 2.33 Inch O.D.
- Redline
more information >
Continue Researching
- Q&A: Grease Seal Recommendation to Replace AD2527E
- Q&A: Replacement Trailer Grease Seal for an NOK AD2527E Seal on a Boat Mate Trailer
- Q&A: Replacement Boat Trailer Seal for a NOK AD2527E Grease Seal
- Q&A: Can I use a different seal than what comes with DX22XR
- Q&A: Ranger Trailer Cool Hub Replacement Grease Seal AD2527E
- Q&A: Diagram of the Dexter Self-Contained Hydraulic Jack- Square Tube DX72CR
- Q&A: Replacement for a TDE Model LP7000 Brake Actuator
- Article: Most Popular Wheel Bearings
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Measure a Trailer Axle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Tire Sizing
Jameson C.
12/1/2025
Hey Dane, how did the grease seal end up working out for your trailer hub? It’d be great to know if the flush fit of the 168233 seal performed well compared to your offset one. Your feedback could help others with the same setup.