Oval Tail Light for Trailer With Separate Wiring
Updated 11/13/2025 | Published 10/21/2025
Products Featured in This Question
Question:
I’m looking for an oval lamp that has separate brake, turn signal and tail lamp inputs. So a 4 wire with no back up lamps. Do you have a recommendation. LED or std doesn’t matter. Thx
asked by: C V
Expert Reply:
At this point all of our oval tail lights are going to have combined wiring so the stop and turn signals run on the same circuit. The best solution would be to use the LED Trailer Light w/ Reflector # 328-003-6016 you were looking at along with the Roadmaster Brite-Lite 3-to-2 Tail Light Converter # RM-732. The converter will combine your right/left turn and stop signals so you can use the majority of the trailer lights out there.
(click to enlarge)
Product Page this Question was Asked From
LED Trailer Light w/ Reflector - Brake, Tail, Turn - Submersible - Surface Mount - Oval - Red
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Surface Mount
- Non-Submersible Lights
- LED Light
- 7-1/2L x 3-1/4W Inch
- Red
- Command Electronics
more information >
Continue Researching
- Q&A: How Does The Cummins Onan P11000iTF Paralleling Kit Work?
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Q&A: What's the RV Designer Motorhome Entrance Door Lock w/ Deadbolt RD68SR Made of?
- Q&A: Replacement Fireplace For The Greystone F2655BCFW Fireplace
- Article: Trailer Lighting Requirements
- Q&A: AL-KO 7230 Hub and Brakes Replacement Parts
- Q&A: Replacement Control Module for Lippert Ground Control 2.0 17410
- Q&A: Replacement Trailer Tail Light for a DOT SAE A216S2T2L 18
- Article: Trailer Wiring Diagrams
- Article: How to Measure a Trailer Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
Robin H.
11/13/2025
Hey, how did things go using the LED trailer light with the Brite-Lite converter? Your update could make it easier for the next person trying to match separate brake and turn signal wiring.