Does Go Power Pure Sine Wave Inverter GP85QR Have Battery Type Settings In App?

Question

Question:

Does the GP85QR inverter/charger let you change battery type settings through the PowerTrak app?

asked by: Sonia

0

Expert Reply:

Great question, Sonia. Yes, the # GP85QR charger can be configured for lithium, AGM, or flooded lead-acid, and you can adjust those settings through the remote or the app. Once set, the inverter remembers the profile, even if you disconnect the remote. That way your batteries always get the right multi-stage charging.

What battery chemistry are you running now?

expert reply by: Andrew N

0

Answer 1

Hello Ernest; the Go Power Pure Sine Wave Inverter Charger #GP85QR can be mounted horizontally with the base down or up. It can also be wall mounted with the terminals facing left or right. You cannot mount it on the wall vertically. See the attached…

view full answer...

Answer 2

Yes, Marsha, that’s exactly what the #GP85QR is built for. Unlike the single-leg 30A #GP44XR, this one outputs on both legs, so it ties directly into a 50A distribution panel and supplies up to 3,000 W (not going to power the entire AC system of…

view full answer...

Answer 3

Steve, for the #GP44XR (along with other models like the #GP85QR and #GP94XR) you’ll want at least 4" of open space on all sides, especially around the fan vents. These units can move a lot of air under load. Mounting it in a ventilated…

view full answer...

Answer 4

Hello Chuck, The correct screen for the Go Power MPPT Solar Charge Controller – PowerTrak – 12V and 24V – 30 Amp #GP32QR is the Go Power PowerTrak Screen – Touchscreen RV Control Panel – Auto-Dimming – Multi-Orientation #GP64XR. The Go Power!…

view full answer...

Answer 5

Yes, the Roadmaster LubeMaster Dry Silicone Spray #RM-747 will also work great for your awning.

view full answer...

Answer 6

Laura, yes, Go Power added app monitoring to the new inverters like 1,800w 30A #GP94XR, 3,000w 30A #GP44XR, and 3000w 50A #GP85QR as long as the control panel #GP64XR is also a part of your setup. Once it’s wired in, you can pull up real-time battery…

view full answer...

Answer 7

Kent, all of the new PowerTrak inverters, such as #GP94XR, #GP44XR, and #GP85QR, are PowerTrak compatible, which means they speak RV-C language and integrate with Go Power’s lithium batteries and controllers. The #GP85QR just goes a step further by…

view full answer...

Answer 8

Sam, for a 3,000W inverter like #GP44XR or #GP85QR, you’ll want 2/0 or 4/0 AWG depending on the length of the run. Keep it under 10 feet if you can, since voltage is your enemy here. Go Power sells install kits that include the right fuse and cabling…

view full answer...

Answer 9

Tyler, the #GP85QR will work with either shore power or a generator input. When you fire up your Onan, the inverter/charger’s built-in transfer switch senses the AC and routes it straight through to your RV’s panel, while also using that power to…

view full answer...

Answer 10

Great question, Drew. The #GP85QR does have a built-in transfer switch and charger, but it’s not a hybrid inverter/charger that can blend shore power with battery power at the same time. What it does is automatically switch between shore (or…

view full answer...

Answer 11

Sherry, you’re right they both deliver 3,000 watts pure sine, but they’re meant for different rigs. The #GP44XR is a straight inverter - DC in, AC out - on one 30A leg, perfect for travel trailers or smaller Class Cs. The #GP85QR is an…

view full answer...

Answer 12

Hey Robert, The Go Power Solar Charge Controller #GP32QR doesn't have a hand held remote, but it does have a touch screen mount #GP64XR that will allow you to control it. Which comes with Bluetooth capability so you would be able to control it…

view full answer...

Does Go Power Pure Sine Wave Inverter GP85QR Have Battery Type Settings In App?

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching