Do You Have the etrailer 2 Swivel Jacks w/ Bolt-On Mounting Plates in a Higher Capacity than 3k?
Updated 09/16/2025 | Published 09/07/2025 >
Products Featured in This Question
Question:
Do you have a bigger weight capacity set? e94RV We want to install them on an 22k gvwr trailer where we load a skid steer that weighs 12k. It lifts up the ram 2500 truck as it goes over the back edge. These might be good enough, but if you had a heavier rated set, Id like to know
asked by: Philip
Expert Reply:
Hello Philip,
We don't have them available as a pair, but you could purchase (2) of the Round, Pipe Mount Swivel Jack w/ Footplate - Weld On - Sidewind - 15-1/2" Travel - 7K # TJP-7002S-B. I’d like to mention that these would need to be welded on, whereas the # e94RV is a bolt-on option.
What kind of business are you running?

Philip
9/16/2025
Can you provide some additional dimensions I am not finding. Given our situation, we need to check clearances. What is the distance from the center of the mounting pipe that is welded on to the top of the jack? What is the distance from where the pipe welds on vertically out to the jack itself, IE how much overhang if we are welding to an I-Beam will it be able to swing down and clear the I-Beam. Thank you.

Product Page this Question was Asked From
etrailer 2 Swivel Jacks w/ Bolt-On Mounting Plates - Sidewind - 15-1/2" Lift - 3,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Sidewind Jack
- 2001 - 3000 lbs
- Manual Jack
- 15-1/2 Inch Lift
- Bolt-On
- With Rectangle Foot
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is Bracket Height for etrailer 2 Swivel Jacks e34RV and e94RV
- Q&A: Difference Between etrailer Swivel Jack e22ZV and e34RV
- Q&A: Overall Height of Round Pipe Mount Swivel Trailer Jack 7,000 lbs
- Q&A: Recommended Swivel Stabilizer Jacks w/ Bolt on Mounting Brackets
- Q&A: Can You Mount Steel Trailer Jacks on an Aluminum Trailer Without Corrosion?
- Q&A: Extended and Retracted Dimensions of the etrailer 2 Swivel Jacks w/ Bolt-On Mounting Plates
- Q&A: Looking for Lug Nut and Locking Lug Nut for Spare Wheel Carrier for Trailer
- Article: Trailer Lighting Requirements
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
- Article: Determining Trailer Tongue Weight
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide



Philip
9/16/2025
Weld on is even better. We are a marine construction company.