Are there 4 Bolt Lug Pattern Disc Brake Kits?
Updated 05/05/2025 | Published 05/02/2025 >
Question:
4 bolt hub pattern on 8 disc Brakes ? Are four bolt disc brakes sets available ?
asked by: Dick R
0
Expert Reply:
Sorry Dick, there are no disc brake kits available with a 4-bolt pattern. If you could get me the part numbers off of your hubs bearings I can find you a 5 lug pattern set but you will need to replace your wheels.
What kind of trailer do you have and what type of hub set up are you currently running?
expert reply by:
Jerred H
0
Product Page this Question was Asked From
Kodiak Disc Brakes - 8" Hub/Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs - E-Z Lube
- Trailer Brakes
- Disc Brakes
- Marine Grade
- 5 on 4-1/2 Inch
- Hub and Rotor
- 1/2 Inch Studs
- 3500 lbs Axle
- 10 Inch Wheel
- 12 Inch Wheel
- 13 Inch Wheel
- Kodiak
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Disc Brake Hubs, Lines, and Hydraulic Actuator for a Boat Trailer w/a 3,500 lbs Axle
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Does DeeMaxx Disc Brake Kit DE66AR Work With Lippert ABS Controller?
- Q&A: Replacement Disc Brakes for Trailer With Dexter Disc Brakes
- Q&A: Replacement Actuator for UFP A-60 34044
- Q&A: Troubleshooting Surge Brake Boat Trailer that Makes Slamming Sound When Hitting Bumps
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Q&A: Surge Brake Actuator Replacement Recommendation for Atwood Model 84132
- Q&A: How to Wire Reverse Lockout Solenoid Kit for Demco DA66B Hydraulic Brake Actuators
- Article: Trailer Wiring Diagrams
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Brake Controller Installation: Starting from Scratch
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Printable Trailer Bolt Hole Pattern Template


Dick
5/5/2025
Hi Jerred: I'm making a M422 Jeep a daily driver. I could adapt a 5 bolt pattern to the existing 4 bolt pattern I now have. It's just alot more machining and fabricating. My interest is in the 8"-disc Brake Dick