Will Curt Round Bar Weight Distribution System Fit V-Nose With 32" Of Space

Updated 10/22/2025 | Published 04/03/2025

Products Featured in This Question

Curt Round Bar Weight Distribution System w/ Friction Sway Control - 10K GTW, 1K TW

(478)

$437.98

Chain Hangers for Curt Weight Distribution Systems - Bolt On

(34)

$46.09

Question:

I am looking at the C17062 to put on a V-Nose enclosed trailer. I see the dimensions to the center of the chain, but wanted to confirm the fit with you. From the center of the coupler to the trailer is 32 which I think is enough clearance, but cutting it close.

asked by: John S

Expert Reply:

Hey John! The # C17062 is to close to really know with only 32" from the coupler to the trailer body. The bars sit approximately 30" back (they measure 30-5/8") and that bracket is 4" wide so it would be another 2".

I'm assuming your 32" measurement is on the inside (which would be the short side) meaning you have a little more space available on the outside. Is that correct? What you can do is use the Chain Hangers for Curt Weight Distribution Systems # C17005. These bolt onto the outside of the frame which should give you the extra bit of clearance needed to install the WDH.

expert reply by: Robin H

Chain Hangers for Curt Weight Distribution Systems
(click to enlarge)

Robin H.

10/22/2025

Hey John, how did things turn out with the Curt weight distribution system on your V-nose trailer? Did the bolt-on chain hangers give you the extra clearance you needed? Your update could make it easier for the next person working with a similar setup.