How Would Go Power Solar AE-6 Wire to 2025 Grand Design 337RLS
Updated 10/27/2025 | Published 03/25/2025 >
Question:
I’m installing 3 60 Amp MPPT solar controllers and panels into my 2025 Grand Design 337RLS. I’m confused about the battery +/- and the load +/-. My RV came with one 60 Amp MPPT, but I’m replacing it with 3 GoPower MPPT’s. I know to connect the RS485 connectors, and to do the main/slave configuration. My RV has a circuit board that has 3 inputs labeled ‘solar prep”. The circuit board has one battery input, one converter/charger input, and the 3 solar prep inputs. I don’t want to send the power to the same circuit board 2 ways, and overload something . Do I take the load +/- to the circuit board, and the battery +/- to the battery?
asked by: Guy W
Expert Reply:
Hey Guy, so the solar chargers that come with the Go Power Solar AE-6 All Electric System with 3 MPPT Solar Controllers # 342-75011 are designed to run straight to the battery. The solar prep circuits on your converter are probably solar chargers themselves so you would not need to utilize them and instead would just want to route the Go Power chargers straight to the batteries.
Product Page this Question was Asked From
Go Power Solar AE-6 All Electric System with 3 MPPT Solar Controllers - 1,200 Watt Solar Panels
- RV Solar Panels
- Roof Mounted Solar Kit
- Rigid Panels
- 801 - 1200 Watts
- 10.1 Amps or More
- AGM
- Gel
- Lead Acid
- Lithium
- Expandable
- MPPT
- 6 Panels
- Go Power
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended 1,200 Watt Solar Panel Kit w/ Controllers, Wires, Connectors, and Installation Hardware
- Article: How Much Solar Power Do I Need For My RV?
- Q&A: Parts Needed to Connect Go Power PowerTrak Screen, Inverter, and Solar Charge Controller
- Q&A: What Cables are Needed for Adding a Second Solar Charge Controller to a Go Power System?
- Q&A: How Much Solar Power is Needed for Refrigerator in 2020 Brookstone 310RL
- Q&A: Wiring Diagram for 4 Panel Go Power Solar Panel Kit 342-75010
- Q&A: Can I Add Additional Panels To The Go Power Solar AE-4 All Electric System?
- Q&A: Drawing Schematic of Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Can You Flat Tow a 2024 Chevy Blazer?
- Article: Calculating Portable Generator Power Needs



Jameson C.
10/27/2025
Hey Guy, how did things go wiring the three Go Power MPPT controllers straight to your batteries? Your results could really help others setting up a similar solar system in their RV.