Can a Second Set of Switches Be Added to the Valterra E-Valve Electric Waste Valve

Question

Question:

I want to have remote switches inside the motorhome as well as switches in the sewer compartment. How would I do this. Can I get a second set of switch plates? Would they all use a common power source?

asked by: Michael

0

Expert Reply:

Hey Michael, yes you can add a second set of switch plates to the Valterra E-Valve Electric Waste Valve System for RV Black and Gray Water Tanks # VAL95MB but unfortunately the switches are not sold separate.

You might be able to wire in two electric valves, but both would either open or close together and the switches might not be rated for the load of 2 electric valves.

If you need anything else, please feel free to drop a comment and let me know!

expert reply by: Bryce D

0

Michale

3/25/2025

Sorry about the previous response. Your response actually contained the answer. Yes I can do it, but they don't offer separate switches.

Answer 1

The rooftop condenser unit can be replaced with a model like the Advent Air Replacement RV Air Conditioner for Dometic Setup #ACDOM150, you'll just want to determine the connector style for the current unit. It will have either a 6-pin or 9-pin…

view full answer...

Answer 2

Hey Vince, the Valterra E-Valve Electric Waste Valve System for RV Black and Gray Water Tanks #VAL95MB does need to connect to a 12 volt power source so you could run it to your batteries directly if that's an option?

view full answer...

Answer 3

Hey Larry, Yes, The Valterra #VAL95MB is a kit with both the #VAL35MB 3" and #VAL55MB 1-1/2" included. They kit them together for a convenient full replacement system, or we offer them both separately as well. Are you looking to get both…

view full answer...

Answer 4

Hey Mike! The Advent Air RV Air Conditioner #ADV74QR is only designed to work with an R32 setup. Your old unit is going to be R410A, so the old components won't be compatible. Since everything moved to R32 last year due to EPA regulations a…

view full answer...

Answer 5

Hey David! The B&W Turnoverball #BW73FR does allow the installation of a 5th wheel hitch as well. That is one of the best things about this system. You will need the B&W Companion #BWRVK3500-5W or #BWRVK3400-5W (slider). Both install using…

view full answer...

Answer 6

It sure is Barry! The SoftStartRV Soft Start item #SSR54FR is exactly what you need for a Furrion AC unit. It'll lower the amps required during startup so you can run other appliances at the same time or power your Grand Design off of a…

view full answer...

Answer 7

It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero Point Calibration The…

view full answer...

Answer 8

Hey Patrick, to end up with two 3 inch diameter electric waste valves what you'd want is two of the LaSalle Bristol MotoDrain waste valve part #LSB42TR as we don't have a kit like what you referenced with both 3 inch sizes. Do you have a…

view full answer...

Answer 9

Hi Glen, It will depend on what the GVWR (gross vehicle weight rating) is of your trailer to determine which B&W 5th wheel to gooseneck adapter will work best for you. Fifth wheels and gooseneck trailers go off of pin weight instead of tongue…

view full answer...

Answer 10

It sure will Shawn. The B&W 5th Wheel to Gooseneck Pin Box item #BW73RV does indeed come with the required safety chains. This pin box is designed to replace a Lippert 1621, 1621HD, 0719, Fabex PB 600 Series pin box. There is also a shim kit item…

view full answer...

Can a Second Set of Switches Be Added to the Valterra E-Valve Electric Waste Valve

Product Page this Question was Asked From

Continue Researching