Solution for Needing Replacement Light in Optronics LED Porch Utility Light

Question

Question:

I have an OPT24WR light on my trailer and need a new bulb. It is a SMD 16 diode LED. Where would i buy a couple of bulbs?

asked by: Myrl F

0

Expert Reply:

Hey Myrl, the light inside the Optronics LED Porch Light part # OPT24WR that you referenced is not replaceable. Only solution would be a new light assembly. How long did the light last in yours? LEDs are supposed to last a very long time.

expert reply by: Jameson C

0

Answer 1

We have several great options to select from but we do not have an exact replacement to the light you currently have. The Gustafson RV Puck Light - 4-1/2", #277-000344 has overall dimensions of 4-1/2" diameter x 1-1/2" tall. Another…

view full answer...

Answer 2

I do have an option for you but the handles included with the Cam-Action Lockable Door Latch Kits like part #PLR658-SSP must be welded to the pole as there are no other options to attach them. If you can get away with a 55" long pipe then you…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...

Answer 11

Great question, William! The Karrier ST225/75R15 #KE63KV is a KR35 while the Karrier ST225/75R15 #AM10303 is a KR03 according to Kenda. There is a slight variation in the tread pattern and from what Kenda says about them it looks like the KR03 is…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Solution for Needing Replacement Light in Optronics LED Porch Utility Light

Product Page this Question was Asked From

Continue Researching