Can The MORryde Manual Storage Reel MR47RR Be Used On A Momentum 350G?
Updated 12/15/2025 | Published 11/26/2024
Question:
I have a momentum 350 G would like to install the 50 foot 50 amp manual cord reel on the wet base side which narrows do you know if they will fit this model?
asked by: Dan G
Expert Reply:
Hello Dan, thanks for reaching out. The MORryde Manual Storage Reel # MR47RR is not a custom fit part, so I cannot guarantee fitment based on the model of RV. Basically as long as you have room for the storage reel it will work for you. Take a look at your desired mounting location and as long as you have room for the 21" long x 10-1/2" wide x 17-5/8" tall storage reel you will be good to go.
Product Page this Question was Asked From
MORryde Easy Reel Spooler - Manual Storage Reel for 50' Long Power Cords - 17-5/8" Tall
- Accessories and Parts
- RV Power Cord
- Storage
- MORryde
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does the MORryde Easy Reel Spooler Work w/a Hardwired Power Cord?
- Q&A: Will The B&W Companion BWRVK3775 Fit 2026 GMC Sierra 3500HD AT4 With A Short Bed And Puck System
- Q&A: Can Watchdog Power Center Surge Protector and Voltage Booster Wire to Outlet of RV
- Q&A: Will The MORryde Manual Storage Reel # MR47RR Be Able to Hold 50' of 50-Amp Cord?
- Q&A: How to Pick Out Replacement Cable Length for Trailer Torsion Ramp Spring
- Q&A: Lighter 5th Wheel Hitch for a Ram 2500 w/ a 6-1/2' Bed and the Factory Puck System
- Q&A: Mounting Location for the Repeater on the TireMinder i10 TPMS
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How Much Solar Power Do I Need For My RV?
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: How to Measure a Trailer Axle
- Article: How to Raise Your Travel Trailer Height
Jesse M.
12/15/2025
Hey Dan, how did things go with fitting the MORryde manual storage reel on your Momentum 350G? Were you able to find enough space on the wet base side for it? Your update could make it easier for the next person working on the same setup.