How to Determine Correct Hub For Harbor Freight Trailer For 13 Inch Wheel

Updated 04/04/2025 | Published 11/12/2024

Products Featured in This Question

Trailer Idler Hub Assembly for 2K Axles - 13" to 15" Wheels - 5 on 4-1/2 - Pre-Greased

(1536)

$54.90

Dexter Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2

(916)

$76.93

Question:

Hello, I am assembling a 1090 lbs 40x48 harbor freight utility trailer. the axle that comes with it has a total of 53” end to end, and a 38” distance between the leaf center bolts. Everywhere I look the smallest axle available is 61/46, that will just not fit. My rod diameter is exactly 25mm, so I am considering at least putting wider wheels 13” but for that I need to replace the hub, ideally putting a 5 lug one. Can you suggest any hub options, or even better axle options? Thank you for your time! Regards

asked by: Andrei T

Expert Reply:

Hello Andrei,

There isn't an axle we can offer as there aren't any that small we have, but you may be able to get a different hub. I couldn't find the bearing sizes of that axle to find a new hub so you'll have to do a bit of measuring. For that you will need to take apart your current hub assembly and look at the bearings themselves; wipe away the grease and you should be able to see the part number stamped directly on them.

If you are unable to find them, you need to use a digital caliper and measure your spindle where the bearings ride, like in the diagram I added below. So for example, if your bearings are L44649 (1.063" inner diameter) you would use the Trailer Idler Hub # AKIHUB-545-2-LF-2K, which is for 13" to 15" wheels.

I have added a link below to our entire selection of hubs for you once you find this info.

expert reply by: Kyle S

Where to Measure Spindle
(click to enlarge)

Andrei T.

11/12/2024

I have a simple caliper, and these are my measurements: outer bearing set 25 mm inner bearing set 25 mm slightly bigger, not 26mm grease seal seat almost 30 mm, bigger than 29mm spindle shaft between 32 and 33 mm thread diameter almost 22, bigger than 21

Kyle S.

11/12/2024

@AndreiT Unfortunately we don't have anything with those exact measurements. The closest is # 8-258BTUC1, which uses bearings L44643 with a 1.000" inner diameter, and grease seal with 1.249" inner diameter. Those are the closest to what you have, though I can't guarantee it will work without specific measurements from a digital caliper. I did want to at least mention it for you if you want to take the chance to see if it works.