Can Seal From MaxxAir Replacement Roof Flange Assembly be Sold Separately

Question

Question:

Hi there, I am looking for the seal part number 11-00026 that goes in this flange. I need the seal by itself, not the whole flange replaced. Any ideas where I can find one? Maxxair does not sell them solo. Thank you

asked by: Dana S

0

Expert Reply:

Hey Dana, thanks for reaching out!

The only way we are able to sell the seal in the flange is to sell the whole Replacement Roof Flange Assembly # MA49FR the same as MaxxAir. We unfortunately don't have the seal separately, or even a makeshift seal.

expert reply by: Jon G

0

Robin H.

12/22/2025

Hey Dana, were you able to find a seal that worked for your MaxxAir flange? Knowing what solution you ended up with could help others trying to replace just the seal.

Answer 1

The inner shroud of the vent is for looks only so it's very concerning that you're getting water through the cracks in it from overtightening the mounting screws. This would be an indication that you have a leak originating somewhere up on…

view full answer...

Answer 2

The whole vent would have to come out. I wish there was a way to just pull out the components of it from the inside but in reality you have to take it apart from the bottom and the top so that you can pull the vent out completely and be able to…

view full answer...

Answer 3

According to Airexcel, the manufacturer of MaxxFan, their #MA49FR replacement roof flange assembly is compatible with their #MA00-07500K 7500K MaxxFan deluxe fan. I've provided a drawing showing the dimensions of the flange as well as a link to…

view full answer...

Answer 4

It seems like you have the ADTH 1RV-200 Motor which has a capacity of 6,500 lbs. You can use this replacement motor #LC142178 which has a 4" on center mounting hole spacing. This one is a bit heavier duty than your other which could prevent it…

view full answer...

Answer 5

From what I could find it looks like your ADTH 1RV-200 motor has a weight capacity of 6,500 lbs. You can use a motor that is rated for a higher capacity, like our replacement motor #LC142178 for Ram landing gear which is rated at 8,000 lbs. Just keep…

view full answer...

Answer 6

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 7

Yes, the Progressive Dynamics part #PD9260C will work great as a replacement for the Magnetek 900 series model 950 that you have currently.

view full answer...

Answer 8

Hey David, so the easiest solution that is very cost effective would be to go with the Advent Air for Dometic Setups part #ACDOM135. This was specifically designed to replace Dometic units so the install is as easy as it can be since the wiring plugs…

view full answer...

Answer 9

For an RV with a currently installed Dometic Duo-Therm 59516.531 AC unit, I recommend the Advent Air for Dometic Setups, #ACDOM150. This is a 15,000 Btu replacement option that plugs directly into your current Dometic setup and works seamlessly with…

view full answer...

Can Seal From MaxxAir Replacement Roof Flange Assembly be Sold Separately

Product Page this Question was Asked From

Continue Researching