Grease Cap for Kodiak KHR1389D and Spindle for 2021 Forest River Riverstone 39RKFB
Updated 01/05/2026 | Published 09/24/2024
Products Featured in This Question
Question:
Good Morning, We are looking at getting some spare axel/brake parts for our 21 Forest River Riverstone 39RKFB. I have the majority of the part numbers for work weve had done but dont have the numbers for the following items. Do you sell the grease cap/oil cap for the Kodiak 13 Hub/Rotor - Part number KHR1389D? Secondly I am looking to get a spare spindle but cant locate a part number on the ones installed on the fifth wheel. Is it possible to figure out the spindle based off of the above mentioned rotor Part number KHR1389D? Thanks, Jon
asked by: Jonathan V
Expert Reply:
Hello Jonathan; the correct grease cap for the # KHR1389D is the Replacement Grease Cap for Kodiak 7,000-lb, 7,200-lb, and 8,000-lb Disc Brake Kits # KPCAP. The hub and rotor are designed for 7,000 - 8,000 lb axles. Our spindles only go up to 7,000 lbs so if you have an 8k axle we don't have one with a high enough rating. Otherwise you can use the #42 E-Z Lube Spindle w/ Flange for 5.2K to 7K Trailer Axles # TRU37FR. If you aren't sure, the capacity should be listed on the axle tag.
Product Page this Question was Asked From
Kodiak 13" Hub and Rotor - 8 on 6-1/2 - Dacromet - 9/16" Bolts - 7,000 lbs to 8,000 lbs
- Trailer Hubs and Drums
- Hub with Rotor
- Standard
- 25580 / 02475
- Marine Grade
- For 7000 lbs Axles
- For 8000 lbs Axles
- 9/16 Inch Stud
- 8 on 6-1/2 Inch
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- 17 Inch Wheel
- 17-1/2 Inch Wheel
- Kodiak
more information >
Continue Researching
- Shop: Replacement Grease Cap for Kodiak 7,000-lb, 7,200-lb, and 8,000-lb Disc Brake Kits
- Q&A: What is the Difference Between the Dexter 010-036-00 and the Timken TMK98ZR Grease Seals?
- Q&A: Are There Any 16 8-Bolt 5/8 Lug Trailer Wheels
- Q&A: Can I Swap Out My Kodiak Hub and Rotor for a Deemaxx Hub and Rotor?
- Q&A: Cross Reference Chart for Kodiak Trailer Disk Brake Pads to Automotive Applications
- Q&A: 6-Pin Round Vehicle Connector To 7-Pin Round Commercial Trailer Connector
- Q&A: Recommended Power Winch For Raising Enclosed Trailer Door Ramp
- Q&A: Cross Reference for Kodiak Ceramic Brake Pads # K2250CP
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Brakes Not Working? Troubleshooting Guide
- Article: Trailer Wiring Diagrams
Robin H.
1/5/2026
Hey Jonathan, how did things go with the grease cap and spindle options for your Riverstone fifth wheel? Were you able to confirm the axle rating from the tag? Your update could make it easier for others working with the same Kodiak hub and rotor setup.